Switch Functions

Content Source: 2020 Indian FTR 1200 Owner’s Manual (9931115 R02) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Switch Functions

Ignition/Light Key Switch

Motorcycle riders must remain as visible as possible at all times. To aid in this, the headlight must be on at all times while operating. The headlights automatically operate when the engine is running. Do not modify the ignition/light switch wiring to circumvent the automatic headlight feature.

The ignition/light key switch controls the electrical functions of the motorcycle. Before starting the engine, read the instructions for starting the engine. See Starting the Engine.

NOTE

Turn the ignition switch to the OFF position, push the key into ignition while turning it to the LOCK position, and remove the ignition key when leaving the motorcycle unattended.

Push the key into the ignition switch while turning it to the PARK position. In PARK, the taillight, front position lamp, indicator lights, and license plate light illuminate. Vehicle powered accessories (if equipped) can be operated and the instrumentation is active. The ignition key can be removed.

Symbol	Description
	Steering Lock
	OFF
	RUN
	PARK

Cruise Control Switch

Cruise control can be activated and adjusted from the left hand control using the Cruise Control Switch

Toggle Position	Function
Down	Set/Decelerate
Center	Off/On
Up	Resume/Accelerate

Turn Signal/Hazard Switch

Turn Signals

To activate the turn signal, press the turn signal switch

in the corresponding direction. To activate the right turn signal, press the turn signal switch to the right. To activate the left turn signal, press the turn signal switch to the left.

Hazard Signal

The power switch must be ON to activate the flashers, but once activated, the flashers will continue to flash when the power switch is turned off. When the flashers are active, all four turn signals flash.

To activate the hazard signal, press on the center of the turn signal switch

Press and hold the switch to activate the flashers.
Press the switch again to cancel the flashers.

Horn Button

Press the horn switch

to sound the horn.

Engine Stop/Run Switch

Use the engine stop/run switch to turn the engine off quickly. Turn the key off after the engine stops.

Press the top of the rocker switch (STOP) to turn the engine OFF.
Press the bottom of the rocker switch (RUN) to start and run the engine.

TIP

The headlight and any accessories plugged into power ports will remain on until the ignition key is turned to the off position.

Trigger Switches

All models are equipped with trigger switches on the front side of the left and right handlebar controls

NOTE

The ignition switch must be in the ON position for the trigger switches to function.

High/Low Headlight Switch

The headlights automatically come on when the engine is started.

The high/low headlight switch

toggles the headlight between high beam and low beam. To momentarily flash headlights (Flash to Pass), press and hold the left-hand trigger switch. To activate high beams for an extended period of time, push the trigger forward until it clicks into place. Pull the lever back to the neutral position to return to low beams.

Right-Hand Trigger

On models equipped with analog gauge, use the right-hand trigger switch to cycle through the multi-function display. See Multi-Function Display Modes.