Content Source: 2019 Slingshot Owner’s Manual (9928978 REV 05) > Pre-Ride Inspections Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Introduction

To keep your vehicle in safe operating condition, always perform the recommended pre-ride inspections before each use of the vehicle. This is especially important before making a long trip and when removing the vehicle from storage.
WARNING
Failure to perform the recommended pre-ride inspections could result in component failure while riding, which could result in serious injury or death. Always perform the pre-ride inspections before each ride. When inspection reveals the need for adjustment, replacement or repair, perform the service promptly.
You must be familiar with all instruments and controls to perform the pre-ride inspections.
NOTE
During the pre-ride inspections you may use products that are potentially hazardous, such as oil or brake fluid. When using any of these products, always follow the instructions and warnings on the product packaging.
When inspections reveal the need for adjustment, replacement or repair:
  • refer to the maintenance section of this manual
  • refer to the service manual, or
  • your authorized dealer or another qualified person can assist with service
Turn the ignition key to the ON position before performing the electrical pre-ride inspections. Return the ignition key to the OFF position after completing these inspections. If inspection of any electrical item reveals component failure, repair or replace the component before operating the vehicle.
Item Inspection Procedure See Page
Electrical
Front Lights Turn the ignition key on. Verify that the headlights, auxiliary lights (if equipped) and park lamps illuminate. Switch to high beam. Verify that the high beam indicator comes on and that headlamp brightness increases. Adjust headlight aim as needed. Headlamp Aim Inspection Conditions
Rear Lights Verify that the taillights and license plate light illuminate. Apply the brakes and verify that the taillight lamps increase in brightness. -
Turn Signals Verify that the left and right turn signals flash at the front and rear of the vehicle, and that the corresponding indicator lamp flashes in the gauge. -
Emergency Flashers Press the top of the hazard switch to turn the flashers on. Verify that all four turn signals flash, as well as the lamps in the gauge. Press the bottom of the switch to turn the flashers off. Verify that all signals and indicator lamps stop flashing. -
Horn Press the horn button. Verify that the horn sounds loudly. -
Low Oil Pressure Indicator Start the engine and verify that the low oil pressure lamp does not illuminate. -
Steering Check power steering for smooth operation. Steering
General
Engine Oil Level Check the oil level. Engine Oil
Fuel Level View the fuel gauge to check the fuel level. Fuel Level
Coolant Level Check the recovery bottle coolant level. Coolant Level
Tires Inspect tire condition, pressure and tread depth. Wheels and Tires
Wheels Inspect for loose, damaged or missing wheel nuts. Wheel Inspection
Brake Fluid Level Check the master cylinder brake fluid level. Brake Fluid Level
Park Brake Verify that the vehicle does not roll when the park brake is set. Park Brake Lever
Brake System Inspect brake system hoses, connections and brake pads. Check brake pedal for excessive travel or a spongy feel. Brake System Inspection
Throttle Pedal Check throttle pedal travel, ensure smooth operation and full return. Throttle Pedal
Clutch System Check fluid level and pedal travel. Hydraulic Clutch Fluid
Front Suspension Check for suspension wear or damage. Front Suspension
Rear Suspension Check for suspension wear or damage. Rear Suspension
Drive Belt Check for wear or damage. Drive Belt, Drive Belt Condition
Fasteners Inspect entire vehicle for loose, damaged or missing fasteners. Fasteners
Mirrors Adjust for proper side and rear view. -

© Copyright Polaris Industries Inc. All rights reserved.