If your model is equipped with a lockable differential, you can choose to operate with an open differential or a closed differential.
Engaging AWD
- Press the top of the switch to engage All Wheel Drive (AWD). The 4X4 indicator illuminates in the rider information center
to indicate that the vehicle is in AWD. When the AWD switch is on, the front gearcase will automatically engage any time the
rear wheels lose traction. When the rear wheels regain traction, the front gearcase will automatically disengage. There is
no limit to the length of time the vehicle may remain in AWD. Initially, the vehicle's electronic system will not enable the
AWD until the engine RPM is below 3100. Once enabled, the AWD remains enabled until the AWD switch is turned off. If the switch
is turned off while the front gearcase is moving, it will not disengage until the rear wheels regain traction.
All-Wheel Drive (AWD)
Differential Lock
Engage the AWD before getting into conditions where front wheel drive may be needed. If the rear wheels are spinning, release
the throttle before switching to AWD.
| NOTICE |
| Switching to AWD while the rear wheels are spinning may cause severe drive shaft and clutch damage. Always switch to AWD while
the rear wheels have traction or are at rest. |
Disengaging AWD
Move the AWD switch to the center or bottom position to disengage AWD. If the switch is turned off while the front hubs are
driving, they will not release until the rear wheels regain traction.
In some situations, the front gearcase may remain locked after turning the AWD switch off. If this occurs, you may notice
increased steering effort and some vehicle speed restriction. Perform the following procedure to unlock the front gearcase.
- Stop the vehicle.
- Operate in reverse for at least 10 feet (3 m).
- Stop completely.
- Shift into low gear and drive forward.
- If the front gearcase remains locked after following these instructions, see your dealer or other qualified service person
for service.
