Content Source: 2021 Indian Vintage Dark Horse / Indian Vintage / Indian Springfield Dark Horse Owner’s Manual (9939979 R01) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Headlight Lamp Replacement

NOTICE
For vehicles equipped with LED headlights, the headlight is not serviceable. If the headlight becomes damaged or inoperable, the entire headlight assembly must be replaced. See your authorized INDIAN MOTORCYCLE dealer.

Applies to: VINTAGE MODELS/SPRINGFIELD

  1. Remove the six bolts securing the front nacelle headlight shroud. Pull this piece forward to access the headlight.
  2. Remove the sealing boot. Press the looped end of the wire bulb retainer clip and swing the end toward the center of the bulb to release it from the latch tab.
  3. With the wire connector attached, pull the bulb out. Disconnect the wire harness.
  4. Install the new bulb and secure the retainer.
    TIP
    Avoid touching a halogen lamp with bare fingers. Oil from your skin leaves a residue, causing a hot spot that will shorten the life of the lamp. If a lamp is touched, clean it thoroughly with denatured alcohol.
  5. Reinstall the sealing boot. Make sure it seals tightly around the bulb base and lens to prevent condensation.
  6. Reinstall the front nacelle headlight shroud.
  7. Tighten the two (2) top bolts.
    TORQUE
    36 in-lbs (4 Nm)
  8. Tighten the four (4) rear bolts.
    TORQUE
    84 in-lbs (9.5 Nm)

© Copyright Polaris Inc. All rights reserved.