Content Source: 2020 PRO XD Gas Owner’s Manual (9939921 Rev 01) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Console

Image

  • Cup Holder
  • Light Switch
  • Instrument Cluster
  • Ignition Switch
  • Gear Selector (Shifter)

  • Horn Switch
  • AWD Switch (if equipped)
  • Driver’s Side Auxiliary Outlet
  • Passenger Side Auxiliary Outlet
  • Storage Compartment

Auxiliary Outlets

The auxiliary outlets can be used to power standard 12V accessories like a cell phone charger or a power inverter up to 120 watts. The driver’s side auxiliary outlet is always on, even when the vehicle is switched off and the key is removed.  This driver’s side outlet is always on so that a battery maintainer may be connected to maintain the battery while the vehicle is in storage. The passenger side outlet (and the rear outlet on 4000 models) switches on and off with the vehicle. These outlets cannot be used to charge the battery because they disconnect when the vehicle is off. 4000 models have a third auxiliary outlet on switched power located in the center console between the rear seats.

Image

Adjustable Steering Wheel

The steering wheel can be tilted upward or downward for rider preference. Lift and hold the adjustment lever toward you while moving the steering wheel upward or downward. Release the lever when the steering wheel is at the desired position.

Image

Gear Selector

Low gear is the primary driving range for the PRO XD. High gear is intended for use on hard-packed surfaces with light loads. Using high gear for heavy loads, hilly terrain or in wet, muddy conditions will increase the chance of drive belt spinning. An alarm will sound if the vehicle detects belt spin. See the Drive Belt Wear/Spin section on Drive Belt Wear/Burn.
H: High Gear
L: Low Gear
N: Neutral
R: Reverse
P: Park
To shift gears, brake to a complete stop. When the engine is idling, move the lever to the desired gear.
NOTICE
Shifting gears with the engine speed above idle or while the vehicle is moving could cause transmission damage. Always shift when the vehicle is stationary and the engine is at idle.
TIP
Maintaining shift linkage adjustment is important to assure proper transmission function. See your dealer if you experience any shifting problems.

Using Low Range

Always shift into low gear for any of the following conditions.
  • Operating in rough terrain or over obstacles
  • Loading the vehicle onto a trailer
  • Towing loads
  • Driving frequently at low RPM or at ground speeds below 7 mph (11 km/h)

Reverse Alert Beeper

Putting the vehicle into reverse will automatically activate the reverse alert beeper.

© Copyright Polaris Inc. All rights reserved.