Switches

Content Source: 2021 GENERAL XP 4 1000 Owner’s Manual (9939900 R01) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Switches

Ignition Switch

OFF	The engine is off. Electrical circuits are off, except Acc, 12V.
ACCESSORY (if equipped)	The engine is off. Powers the gauge and terminal block. Check engine and steering warning indicators will appear on the gauge in this mode, but will turn off when the vehicle is started if no issues are present.
ON	Electrical circuits are on. Electrical equipment can be used.
START	Turn the key to the START position to engage the electric starter. The key returns to the ON position when released.

The ignition switch is a four-position, key-operated switch. The key can be removed from the switch when it is in the OFF position.

AWD/Differential Lock Switch

The AWD switch has three positions:

All Wheel Drive (AWD)
Two Wheel Drive (2WD)
Differential Unlock (TURF mode)

Light Switch

The ignition switch key must be in the ON/RUN position to operate the headlights. Press the top of the switch to place the headlights on high beam. Move the switch to the center position to place the headlights on low beam. Press the bottom of the switch to turn off the headlights.

Winch Switch (if equipped)

Press the top of the rocker switch to spool line out from the winch. Press the bottom of the rocker switch to spool line in to the winch. Move the rocker switch to the center position to stop spooling.

Bumper-Mounted Light Bar Switch (if equipped)

NOTICE

The bumper-mounted light bar should only be used when operating off-road.

To activate the bumper-mounted light bar, the ignition switch must be in the ACC or ON position. Press the top of the rocker switch to activate the bumper-mounted light bar.