Content Source: 2021 Indian Scout Bobber Owner’s Manual (9931589 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Headlight

Headlight Aim Inspection

On LOW beam, the horizontal cut-off of the light beam should be 4 in. (10 cm) lower than the center of the headlamp bulb and centered straight ahead at 32 ft. 10 in. (10 m).
  1. Verify that tire pressure is at specification. See the Tire Pressure section for details.
  2. Verify that rear suspension ride height (preload) is at specification. See the Rear Shock Preload (Ride Height) Inspection section for details.
  3. Position the motorcycle on a level surface with the headlight 32 ft. 10 in. (10 m) from a wall.
  4. With the operator and passenger (if applicable) on board, bring the motorcycle to the fully upright position.
  5. Start the engine and switch the headlamp to low beam. Observe the headlight aim on the wall.
  6. Make any necessary adjustments to headlight aim.
Image
NUMBER DESCRIPTION
4 in (10 cm) to top cut-off of beam
Measure distance = 32 ft 10 in (10.0 m)
Headlight Center

Headlight Aim Adjustment

Image
  1. To adjust the headlamp vertically, loosen the housing mount fastener and pivot the housing upward or downward. Tighten the fastener.
    TORQUE
    35 ft-lbs (47.5 N·m)
  2. To adjust the headlamp horizontally, loosen the headlight mounting bolt and pivot the headlight to the left or right. Tighten the bolt.
    TORQUE
    18 ft-lbs (24.4 N·m)

Headlight Lamp Replacement

Image
  1. The headlight bulb can be serviced and removed from the back of the headlight bucket without disassembling the headlight lamp.
  2. Disconnect the wire harness .
  3. Remove the rubber boot from the rear of the headlight.
  4. Squeeze the bulb retainer and move it away from the bulb. Remove the bulb.
    NOTICE
    Avoid touching a halogen lamp with bare fingers. Oil from your skin leaves a residue, causing a hot spot that will shorten the life of the lamp. If a lamp is touched, clean it thoroughly with denatured alcohol.
  5. Install the new bulb and secure the retainer.
  6. Reinstall the rubber boot, making sure it seals around the bulb and headlight.
  7. Connect the wire harness.

© Copyright Polaris Inc. All rights reserved.