Content Source: 2021 Indian Challenger Owner’s Manual (9931587 R01) > Cleaning and Storage Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Gloss Clear Coat Finish Care

The clear coat finish system used on all INDIAN MOTORCYCLE provides superior protection against the elements. To maximize the benefits of this system, use the following guide to care for the gloss finish on your motorcycle.
  • During the first 30 days, when the finish is still fresh, clean the motorcycle with a water rinse only.
  • Do not wax the motorcycle for the first 60 days. Doing so can cause loss of the gloss. After 60 days, use only waxes designed for new clear coat finishes.
  • Do not use pressurized water to wash the motorcycle. When paint is still fresh, pressurized water could damage the finish. If using a pressure washer is unavoidable, keep the spray nozzle at least 24 inches (60 cm) away from the surface of the motorcycle.
  • Wash your motorcycle often, especially when exposed to salty, dusty, acidic or alkaline environments.
  • Use warm or cool water and a soft cloth for cleaning.
  • Use soaps that are non-abrasive and have a neutral pH (non acidic/non alkaline detergents).
  • Do not use solvent-based solutions.
  • Do not use a dry cloth to remove dust.
  • Do not use a stiff bristle brush, which can scratch the surface.
  • Do not wash with extremely hot water.
  • Do not wash the motorcycle while the surface is hot and avoid washing the motorcycle in the hot sun. Minerals in the water may be difficult to remove once dried on the surface of the motorcycle.
  • Do not allow spilled gasoline, motor oil or brake fluid to stand on the paint. Remove these substances immediately by rinsing with water. Use a soft cloth to absorb any remaining residue and dab dry.
  • To remove bug remnants or road tar, use only products that are specifically designed for this purpose. Follow the product manufacturer’s recommendations to prevent potential damage to the finish. Follow with a wash using the methods described in this section.
  • Always brush away any ice or snow, do not scrape off.
  • Chips or scratches should be repaired promptly to prevent corrosion.

© Copyright Polaris Inc. All rights reserved.