Content Source: 2021 Indian Challenger Owner’s Manual (9931587 R01) > Instruments, Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Brakes

The front brake lever activates the front brake calipers. The rear brake pedal activates the rear brake caliper. For maximum brake effectiveness, apply the front brake lever and the rear brake pedal together.

Anti-Lock Brake System (ABS)

The anti-lock brake system automatically adjusts brake pressure as needed to provide optimum braking control, reducing the chance of wheel lock-up during hard braking events or when braking on rough, uneven, slippery or loose surfaces. See Anti-Lock Brake System Response.
  1. The anti-lock brake system cannot be turned off.
  2. The ABS indicator always illuminates when vehicle power is turned on. It remains illuminated until the anti-lock system activates, which occurs when vehicle speed exceeds 6 MPH (10 km/h).
  3. When the lamp is illuminated, the anti-lock brakes will not activate, but the conventional brake system will continue to operate normally.
  4. When the anti-lock brakes engage during a braking event, the rider will feel pulsing at the brake levers. Continue to apply steady pressure to the brakes for the best stopping performance.
  5. If the ABS light does not come on when the key is turned to the ON or PARK position, your authorized INDIAN MOTORCYLE dealer can assist.
  • If the lamp continues to illuminate after vehicle speed exceeds 6 MPH (10 km/h), the ABS system is not functioning. See your INDIAN MOTORCYCLE dealer or other dealer promptly for service.
  • Operating with non-recommended tires or improper tire pressure may reduce the effectiveness of the anti-lock brake system. Always use the recommended size and type of tires specified for your vehicle. Always maintain the recommended tire pressure.
  • The anti-lock brake system will not prevent wheel lockup, loss of traction or loss of control under all conditions. Always adhere to all safe motorcycle-riding practices as recommended.
  • It is not unusual to leave tire marks on the road surface during a hard braking event.
  • The anti-lock brake system does not compensate for or reduce the risks associated with:
    • excessive speed
    • reduced traction on rough, uneven or loose surfaces
    • poor judgment
    • improper operation

Front Brake Lever

The front brake lever is located on the right handlebar. This lever controls only the front brakes. The front brakes should be applied simultaneously with the rear brakes. To apply the front brake, pull the lever toward the handlebar. See Braking for braking procedures.
Image
The front brake lever reach (distance to the hand grip) is adjustable. To adjust the front brake lever reach, do the following:
  1. Gently push and hold the lever away from the hand grip. The adjuster wheel is located on top of the lever.
  2. To increase reach distance, rotate the adjuster to a lower number.
  3. To decrease the reach distance, rotate the adjuster to a higher number.

Rear Brake Pedal

The rear brake pedal is located on the right side of the motorcycle. Press downward on the rear brake pedal to apply the rear brake.
Image
WARNING
Resting your foot on the brake pedal will cause excessive and premature wear of brake pads and reduced braking efficiency, which could result in serious injury or death.
See Braking for braking procedures.

© Copyright Polaris Inc. All rights reserved.