Content Source: 2021 RZR S4 1000 Owner’s Manual (9931549 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Filter Systems

Air Filter

Always change the air filter at the intervals outlined in the Periodic Maintenance Chart section.
  1. Remove the cargo box access panel.
  2. Clean all dirt and debris from the air box area.
  3. Unlatch the two (2) air box cover straps and carefully remove the air box cover.
    Image
  4. Inspect the air filter and air box for dirt, debris or water.
    Image
  5. To remove the filter, slide the filter toward the passenger's side of the vehicle.
  6. With the filter removed, clean the intake tube and air box thoroughly. Wipe well with a clean, dry cloth.
    NOTICE
    Dirt or debris in the intake tube could result in severe engine damage. Always clean all dirt and debris from the intake tube before installing the filter.
  7. Reinstall the air filter (if clean) or install a new air filter (if soiled). Do not attempt to clean the air filter.
    NOTICE
    Use of a non-POLARIS-approved air filter may cause engine damage. Always use a POLARIS-approved replacement filter. Please see your POLARIS dealer or authorized person.
  8. Make sure that there are no gaps between the filter and the driver’s side of the air box.
  9. Reinstall the air box cover. Make sure the tabs are properly positioned into the hinge.
  10. Secure the two (2) cover straps.
  11. Reinstall the cargo box access panel.

Spark Arrester

WARNING
Failure to heed the following warnings while servicing the spark arrester could result in serious injury or death.
  • Do not perform clean-out immediately after the engine has been run, as the exhaust system becomes very hot. Serious burns could result from contact with the exhaust components. Allow components to cool sufficiently before proceeding.
  • Wear eye protection and gloves.
  • Never operate without the spark arrester.
  • Never run the engine in an enclosed area. Exhaust contains poisonous carbon monoxide gas that can cause loss of consciousness or death in a very short time.
Periodically clean the spark arrester to remove accumulated carbon. A plugged spark arrester will affect engine performance. Clean daily when driving in mud and water. Replace a cracked or damaged arrester before operating.
  1. Remove the arrester retaining bolt and nut .
  2. Remove the arrester from the end of the muffler .
  3. Use a non-synthetic brush to clean the arrester screen . A synthetic brush may melt if components are warm. If necessary, blow debris from the screen with compressed air.
    Image
  4. Inspect the screen for wear and damage. Replace a worn or damaged screen.
  5. Reinstall the arrester. Torque bolt to 9-11 ft-lbs (12-15 N·m).

© Copyright Polaris Inc. All rights reserved.