Content Source: 2021 RZR XP / XP4 1000 High Lifter Owner’s Manual (9931526 R03) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Instrument Cluster

NOTICE
High water pressure may damage components. Wash the vehicle by hand or with a garden hose using mild soap. Certain products, including insect repellents and chemicals, will damage the speedometer lens and other plastic surfaces. Do not use alcohol to clean the instrument cluster. Do not allow insect sprays to contact the lens. Immediately clean off any gasoline that splashes on the instrument cluster.
Image

  • Speedometer
  • Tachometer
  • Indicator Lamps

  • Mode Button
  • Toggle Buttons
  • Rider Information Center

Speedometer

The speedometer displays vehicle speed in either miles per hour (MPH) or kilometers per hour (km/h).

Tachometer

The tachometer displays engine speed in revolutions per minute (RPM).

Mode Button

Press and hold the MODE button to enter or exit the settings menu. Press and release the MODE button to cycle through Area 1 modes and to select an item.

TOGGLE BUTTONS

Press and release either toggle button to cycle through the options menu or Area 2 modes. Press and hold either toggle button to reset an item. See Gauge Settings Menu.
TIP
With the ignition key off, pressing the MODE button or either toggle button will power up the Rider Information Center for 10 seconds to allow viewing of the odometer and the clock.

Indicator Lamps

Lamp Indicates Condition
Image
 Vehicle Speed When standard mode is selected, speed displays in miles per hour.
Image
 When metric mode is selected, speed displays in kilometers per hour.
Image
 Over Temperature This lamp illuminates to indicate an overheated engine. If the indicator flashes, the overheating condition remains, and the system will automatically reduce engine power.
Image
 Electric Power Steering (EPS) Warning (if equipped) This indicator illuminates briefly when the key is turned to the ON position. If the light remains on, the EPS system is inoperative. See your POLARIS dealer, or other qualified person, as soon as possible for repair. Continued operation could result in permanent damage to the EPS unit and increased steering effort.
Image
 Neutral This lamp illuminates when the transmission is in neutral and the ignition key is in the ON position.
Image
 High Beam This lamp illuminates when the headlamp switch is set to high beam.
Image
 Helmet/Seat Belt This lamp is a reminder to the operator to ensure all riders are wearing helmets and seat belts before operating. The driver’s seat belt is equipped with a seat belt interlock. Vehicle speed will be limited to 15 MPH (24 km/h) if the seat belt is not secured.
Image
 Check Engine This indicator appears if an Electronic Fuel Injection (EFI) related fault occurs. Do not operate the vehicle if this warning appears. Serious engine damage could result. Your authorized dealer or qualified person can assist.
Image
 Check Battery This warning usually indicates that the vehicle is operating at an RPM too low to keep the battery charged. It may also occur when the engine is at idle and high electrical load (lights, cooling fan, accessories) is applied. Drive at a higher RPM or recharge the battery to clear the warning.
Image
 Low Fuel This lamp illuminates when fuel level in the fuel tank is low.
Image
 Speed Key (optional accessory) Information about the speed key is provided in the accessory kit.

© Copyright Polaris Inc. All rights reserved.