Content Source: 2021 RZR XP / XP4 1000 Owner’s Manual (9931524 R02) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Seat Belts

This POLARIS vehicle is equipped with seat belts for all riders. Always make sure the seat belts are secured for the operator and all passengers before riding. The driver’s seat belt is equipped with a seat belt interlock. Vehicle speed will be limited to 15 mph (24 km/h) if the seat belt is not secured.

3-Point Seat Belt

To wear the 3-point seat belt properly, follow this procedure:
  1. Pull the seat belt latch downward and across your chest toward the buckle at the inner edge of the seat. The belt should fit snugly across your hips and diagonally across your chest. Make sure the belt is not twisted.
  2. Push the latch plate into the buckle until it clicks. Pull up on the strap to tighten.
  3. Press the red release latch on the buckle to release the seat belt.

6-Point Seat Belt
(Trails and Rocks Edition)

This vehicle is equipped with a Click-6 safety harness with built-in interlock. To wear the 6-point seat belt properly, follow this procedure:
  1. Pull both the seat belt latch and buckle across your chest.
  2. Push the latch plate into the buckle until it clicks.
  3. Pull on the adjustment straps to tighten the straps on your hips and thighs.
  4. To release the seat belt, press the red release latch on the buckle.

Seat Belt Inspection

Inspect all seat belts for proper operation before each use of the vehicle.
  1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly into the buckle. A click indicates that it's securely latched.
  2. Push the red release latch in the middle of the buckle to make sure it releases freely.
  3. Pull each seat belt completely out and inspect the full length for any damage, including cuts, wear, fraying or stiffness. If any damage is found, or if the seat belt does not operate properly, have the seat belt system checked and/or replaced by an authorized POLARIS dealer or qualified person.
  4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water. Do not use bleach, dye or household detergents. Rinse the entire length of the belt webbing. Use a garden hose to flush out the latch and retractor housings regularly.

Image

Image

Seat Belt Height Adjuster (if equipped)

The seat belt height adjuster reduces neck rub and works as a shock absorber for your shoulder. The height adjuster consists of an adjuster and a rail . Adjustment becomes easier with repeated use. The seat belt height adjuster can be cleaned with water.

Image

  • To adjust the height of your seat belt for desired comfort and proper fit, follow this procedure:
  1. Stretch the seat belt height adjuster toward the front of the vehicle.
  2. While continuing to stretch the seat belt height adjuster, slide the adjuster up or down, rocking it side to side if necessary, until you reach the desired height. This may require both hands. Do not attempt to adjust while vehicle is in motion.
  • Image

  • Image
  • Image

© Copyright Polaris Inc. All rights reserved.