Switches

Content Source: 2021 RZR XP 1000 EU Owner’s Manual (9931389 R01) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Switches

	Light Switch	Ignition Switch
	AWD Switch	12V Accessory Outlet
	Instrument Cluster

Auxiliary Outlets

The vehicle is equipped with one or more 12-volt accessory outlets. One outlet is on the dash, a second outlet (if equipped) is in the rear passenger area. Use the outlets to power an auxiliary light or other optional accessories. For service, the dash outlet connection is under the dash. The rear outlet connection is under the rear passenger seats.

Auxiliary Outlets

Hazard Light

The hazard light is controlled by the turn signal lever. To switch the hazard light to ON position, push the lever forward. Pull the lever backward to switch the hazard light to OFF position.

Headlight Switch

Use the headlight switch to turn the lights on and off and to change the lights from high beam to low beam. The ignition switch must be in the ON position to operate the headlights.

Press the top of the rocker switch toward the dash to place the headlights on high beam

. Move the rocker switch to the center position to place the headlights on low beam

. Press the bottom of the rocker switch to turn off the headlights.

If the headlight switch is ON when the ignition switch is turned off, the lights will remain on for approximately 30 seconds.

Ignition Switch

The ignition switch

is a four-position, key-operated switch. Use the ignition switch to start the engine. The key can be removed from the switch when it is in the OFF position.

	OFF	Turn the key to the OFF position to stop the engine. Electrical circuits are off.
	ACCESSORY	The engine is off. Powers the display and terminal block. Check engine and power steering warning indicators will appear on the display in this mode but will turn off when the vehicle is started if no issues are present.
	POSITION LIGHTS ON	The headlights are off. Position lights are on. Electrical equipment can be used.
	START	Turn the key to the START position to engage the electric starter. The key returns to LIGHTS ON position when released. See the Starting the Engine section for details.

Horn Switch

The horn switch is located on the turn signal lever . Press the tip of the turn signal lever inward to sound the horn.

All Wheel Drive (AWD) Switch

The AWD Switch has either two or three positions, depending on your model’s features:

All Wheel Drive (AWD)
Two Wheel Drive (2WD)
Turf Mode / Differential Unlocked (1WD)

See the All Wheel Drive (AWD) System section for operating instructions.

Turn Signal Lever

Before turning, activate a turn signal to alert others of your intentions. Check turn signal lamps before each ride.

TIP

The key must be in the ON position to activate the turn signals.

Move the turn signal lever downward to signal a left turn. The left turn signal lamps in the taillight and below the front headlight will flash. The turn signal indicator in the gauge will also flash.
Move the lever upward to signal a right turn. The right signal lamps and indicator will flash.
Return the lever to the center position to end the signal.