Hitches (Zugmaschine Only)

Content Source: 2021 RZR XP 1000 EU Owner’s Manual (9931389 R01) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Hitches (Zugmaschine Only)

WARNING

Whenever the vehicle is towing, always stay clear of the area between the vehicle and the towed object.

Rear Hitch

NOTICE

After 1000 km of use, tighten the bolt holding the trailer ball to the hitch to 445 N⋅m.

Use the rear hitch for towing a trailer. See the Hauling Cargo section for details and procedures.

The values given below pertain to factory-installed hitches and are provided for informational purposes only.

IMPORTANT

For vehicle-specific trailering values, see the Specifications chapter.

The vehicle-specific values take precedent if they are lower than the component values shown below.

Rear Hitch Component Specifications
Maximum Vertical Load (S)	85 kg
Maximum Towable Mass	2000 kg
Maximum Dynamic Force (D)	10,2 kN
Approval #	E20 55R-01 4430

Rear Hitch Certification Label

The hitch certification label is located on the hitch bar.

Hitch Removal / Installation

To remove the hitch (if equipped), remove the cotter pin and hitch pin . Remove the hitch, then reinstall the hitch pin and secure the cotter pin .
To install the hitch, remove the cotter pin from the hitch pin and remove the hitch pin .
Install the hitch to the receiver.
Reinstall the hitch pin (from the left side of the hitch) through the bore of both the receiver and the hitch.
Reinstall the cotter pin. Make sure the hitch assembly is secure at that the cotter pin is properly engaged over the hitch pin.

7-Way Trailer Connector

The 7-way trailer connector (if equipped) installed on your vehicle meets the requirements of European standard ISO 1724.
This connector uses all 7 pins on newer model trailers. An older model trailer may not be compatible with this connector.
Improper electrical wiring changes can result in damage to both vehicle and trailer components. When in doubt about your trailer connection, please contact a qualified tow-bar specialist for assistance.