Elevating the Vehicle for Service

Content Source: 2021 RZR XP 1000 Tractor Owner’s Manual (9931388 R01) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Elevating the Vehicle for Service

Some service procedures require that the vehicle be elevated. Before proceeding, remember to:

Always position the vehicle on a firm, level surface before elevating.
Only use an appropriate sized lift or jack.
Refrain from positioning a jack or jack stand under any components other than the vehicle frame.
Refrain from allowing the vehicle to remain elevated on a floor jack for an extended period of time.

Placing onto Jack Stands

Place the floor jack directly beneath the center of the vehicle (either front or rear).
This vehicle is not equipped with dedicated jacking points. Make sure that the floor jack only makes contact with the vehicle frame only while lifting.
After vehicle is elevated to desired height, place jack stands under the vehicle frame on both sides of the floor jack, then lower the vehicle until the jack stands come into contact with the vehicle frame.