Content Source: 2021 INDY VR1 / INDY XC / Switchback ASSAULT Owner’s Manual (9931271 R01) > Features Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Adjustable Headlight

NOTICE
The image below is for reference only. Your model may differ slightly.
Image

Inspection

It is very crucial to correctly complete the steps below in order to achieve optimal headlight performance. The headlight can be inspected for vertical aim using the following procedure.
  1. In a well-ventilated area, position the snowmobile on a level surface with the headlight approximately 25 feet (7.6 m) from a wall .
  2. Place the rider or the approximate weight of the rider on the seat or tunnel floorboards.
  3. Measure the distance from the floor to the center of the headlight and make a mark on the wall at the same height .
  4. Start the engine. Move the headlight switch to low beam.
  5. Observe the headlight aim on the wall. There should be a distinct horizontal line on the wall from the low beam. That line should align with the mark on the wall .

Adjustment

  1. Shut off engine.
    WARNING
    To prevent serious injury, NEVER attempt to adjust the headlight while the engine is running.
  2. If adjustment is necessary, an adjuster knob is located on the back of the headlight, which can be accessed by removing the vehicle’s left side panel.
    NOTICE
    The adjuster knob is located at the rear of the light above the plug.
  3. To LOWER the beam, turn the adjuster knob CLOCKWISE.
  4. To RAISE the beam, turn the adjuster knob COUNTERCLOCKWISE.

© Copyright Polaris Inc. All rights reserved.