Engine Break-In

Content Source: 2022 Indian FTR Owner’s Manual (9931166 R02) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Engine Break-In

The engine break-in period for your motorcycle is the first 500 miles (800 km) of operation. During this break-in period, critical engine parts require special wear-in procedures so they seat and mate properly. Read, understand and follow all break-in procedures to ensure the long-term performance and durability of your engine.

The more cautiously you treat your motorcycle during the break-in period, the more satisfied you will be with its performance later on. Overloading the engine at low RPM and/or running the engine prematurely at high RPM may result in damage to the engine components.

Observe the following precautions during the break-in period:

Upon initial start-up, do not allow the engine to idle for long periods as overheating can occur.
Avoid fast starts with wide open throttle. Drive slowly until the engine warms up.
Avoid running the engine at extremely low RPM in higher gears (lugging the engine).
Drive within the recommended operating speeds and gears. See Operating Speeds and Gears and Shifting Gears While Driving.

NOTICE

Engine calibration can take up to 10 minutes of idle with the coolant temperature above 181 °F (83 °C) without cylinder deactivation enabled to fully adapt when vehicle is new or after a calibration flash.

Operating Speeds and Gears

Odometer	Break-in Procedure
0-90 miles (0-145 km)	Do not operate for extended periods above 1/3 throttle or at any one throttle position. Vary engine speed frequently.
91-300 miles (146-483 km)	Do not operate for extended periods above 1/2 throttle or at any one throttle position. Vary engine speed frequently.
301-500 miles (484-800 km)	Do not operate for extended periods above 3/4 throttle.
At 500 miles (At 800 km)	Perform the break-in maintenance outlined in the maintenance section of this manual. Break-in maintenance should be performed by a dealership. Break-in maintenance must include inspection, adjustments, fastener tightening and an engine oil and filter change. Performing break-in maintenance at the required odometer reading helps ensure peak engine performance, minimal exhaust emissions and maximum service life of the engine.