Content Source:
2020 Indian Challenger Rider’s Manual (9931163 R02) > Pre-Ride Inspections
Chapter
| IMPORTANT |
|
The Owner's Manual for this vehicle contains
warnings, instructions and other information you must read and fully
understand
before safely riding or performing maintenance
on this vehicle.Always follow the warnings and instructions in Owner's
Manual.
Click the CONTENTS link above for the Table Of
Contents, or download a full PDF of the Owner Manual in the Owner
Support area
of Polaris.com
|
Side-stand
- On level ground,
straddle the motorcycle and bring it to the fully upright position.
- Move the side-stand
up to the stored position and down to the fully extended position
several times. It should move smoothly
and quietly. Make sure the return spring holds
the side-stand tightly in place when the side-stand is in the stored
position.
Adjust or replace a loose spring.
- Inspect the side-stand
pivot bolt for looseness or wear. Tighten or replace a loose or worn
bolt.
- Periodically test
the side-stand safety switch for proper operation. With the transmission
in gear and brakes applied, attempt
to start the engine while the side-stand is
down. The engine should NEVER start in any gear except neutral if
the side-stand
is down. If the engine starts during this
test, see your dealer for service.
