Content Source: 2020 Indian Challenger Rider’s Manual (9931163 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Headlight Aim Inspection

NUMBER DESCRIPTION
Stock ECE and CCC compliant measure distance = 7 in. (17.8 cm)
Optional North American only measure distance = 4 in. (10.2 cm)
Measure distance = 32 ft. 10 in. (10.0 m)
Headlight Center
Image
NOTE
Adjust headlight aim when there is a change in load (rider, cargo, accessories, etc.) or after suspension adjustment.
On LOW beam, the top of the horizontal cut-off of the light beam should be 4 in. (10 cm) lower than the center of the headlight bulb and centered straight ahead at 32 ft. 10 in. (10 m).
  1. Verify that tire pressure is at specification.
  2. Verify that rear suspension ride height (preload) is at specification.
  3. Position the motorcycle on a level surface with the headlight 32 ft. 10 in. (10 m) from a wall.
  4. With the operator and passenger (if applicable) on board, bring the motorcycle to the fully upright position.
  5. Start the engine and switch the headlight to low beam. Observe the headlight aim on the wall.
  6. Make any necessary adjustments to headlight aim.

© Copyright Polaris Industries Inc. All rights reserved.