Content Source: 2020 Indian Challenger Rider’s Manual (9931163 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Fuse Replacement

NOTICE
Use fuses with the recommended amperage to avoid damage to the electrical system.

Standard Fuses

The standard fuse box is located under the left side cover. This fuse box houses all standard service fuses and the automatic circuit breakers. Fuse application and size are provided on a label on the fuse box cover.
TIP
Use the fuse puller provided in the tool kit to remove a fuse.
Image
  1. Remove the left side cover. See Side Covers.
  2. To release the locking tabs, squeeze the upper and lower cover clips and remove the fuse box cover.
  3. After replacing a fuse, reinstall the fuse box cover and side cover.

High-Current Fuses

The JCASE® fuse box contains the high-current fuses for the chassis, vehicle control module and anti-lock brake system. This fuse box is located next to the battery box.
Fuse application and size are provided on a label on the fuse box cover.
Image

Electrical Precautions

Be aware of the following precautions regarding the electrical system to avoid disruption of electrical signals and possible system malfunction.
  • DO use ONLY genuine INDIAN MOTORCYCLE parts and accessories designed for your model, and follow the instructions provided.
  • DO use the accessory power jack provided (if equipped).
  • If it is necessary to provide power to an item that does not use one of the previously mentioned power jacks, connect to the load side of the main circuit breaker and connect the ground wire to the engine ground at the front side of the crankcase (near the circuit breaker). The circuit breaker is located under the cover behind the oil cooler.
  • DO NOT splice or cut any wires.
  • DO NOT tap in to any power or ground on the motorcycle unless specifically directed to do so by the INDIAN MOTORCYCLE instructions that come with the kit.
  • DO NOT back-probe electrical connectors on the vehicle unless directed to do so by the INDIAN MOTORCYCLE Service Manual.
  • DO NOT power any accessories from the diagnostic connector (under left side cover).

© Copyright Polaris Industries Inc. All rights reserved.