Content Source: 2020 GEM em1400 LSV Owner’s Manual (9931124-EN R01) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Seat Belts

WARNING
Failure to properly use seat belts can result in serious injury or death. Always follow all legal requirements for seat belt use in on-road vehicles.
  • Always make sure the seat belts are secured for operator and all passengers before operating.
  • Pregnant women should wear the lap part of the belt across the thighs and as snug across the hips as possible. Keep the belt low so that it does not come across the abdomen.

Proper Seat Belt Use

  • This vehicle is equipped with three-point lap and diagonal seat belts for all occupants. Always make sure the seat belts are secured for operator and all passengers before operating.
  • When the key is turned on, the seat belt indicator lamp will illuminate if the driver’s seat belt is not fastened.
  • To wear the seat belt properly, follow this procedure:

Image
  1. Pull the seat belt latch downward and across your chest toward the buckle at the inner edge of the seat.
  2. Slide the buckle up the webbing as far as needed for the belt to reach across your hips. The belt should fit snugly across your hips and diagonally across your chest. Make sure the belt is not twisted.
  3. Push the latch plate into the buckle until it clicks.
  4. Release the strap, it will self-tighten.
  5. To remove slack in the lap belt portion of the belt, pull upward on the shoulder belt. To loosen the lap belt if it is too tight, tilt the buckle and pull the lap belt slightly longer.
  6. To release the seat belt, press the square red button in the buckle’s center. If necessary, slide the buckle down the webbing to allow it to retract fully.

Seat Belt Inspection

Inspect all seat belts for proper operation before each use of the vehicle.
  1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly into the buckle. A click indicates that it's securely latched.
  2. Push the red release latch in the middle of the buckle to make sure it releases freely.
  3. Pull each seat belt completely out and inspect the full length for any damage, including cuts, wear, fraying or stiffness. If any damage is found, or if the seat belt does not operate properly, have the seat belt system checked and/or replaced by a GEM authorized service dealer.
  4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water. Do not use bleach, dye or household detergents.

© Copyright Polaris Inc. All rights reserved.