Content Source: Polaris Power® P3200iE Owner’s Manual (9931063 R03) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Spark Arrester

The spark arrester is located on the end of the muffler.
Image
WARNING
Generator exhaust system gets hot enough to ignite some materials and burn skin if touched.
Allow generator and exhaust to cool before performing spark arrestor maintenance.
caution
The spark arrester must be serviced every 100 hours to maintain its efficiency.
Before performing any inspection or maintenance on the battery, ignition switch should be positioned to OFF.

Removing the Back Panel

The back panel and rear handle of the generator must be removed in order to access the muffler and the spark arrester. Allow the generator to fully cool before touching internal components.

Image


Image
  1. Remove the left handle screw .
  2. Detach the rear cord hook and right handle screw .
  3. Detach rear panel by removing the four screws .

Removing the Spark Arrester

Image
  1. Remove screw holding the spark arrester to the muffler.
  2. Pull the end cap off to remove the arrester screen.
  3. Clean the spark arrestor with a stiff wire brush.
  4. Replace if the wire mesh is perforated or torn.
  5. Reinstall screen and cap. Secure cap to the muffler with the screw.

© Copyright Polaris Inc. All rights reserved.