 WARNING |
| Gasoline is highly flammable and is explosive. You can be burned or seriously injured when handling fuel. Keep heat, sparks,
and flame away. Wipe up spills immediately. |
| NOTICE |
| Using the wrong carburetor main jet may cause poor engine performance. If too lean of a main jet is used, severe engine damage
may result. |
Altitude Kits
| Model |
Part Number |
Description |
| P2000i |
2884865 |
K-HIGH,ALT,3-8K,P2000I |
| P3200iE |
2884866 |
K-HIGH,ALT,3-8K,P3200IE |
| P5500 / P6500 |
2884867 |
K-HIGH,ALT,3-8K,P5500/6500 |
Altitude Jet Specifications
| Model |
Engine |
Altitude |
Altitude Jet Mark |
| P2000i |
79cc |
3000-6000 ft |
68 |
| 6000-8000 ft |
67 |
| P3200iE |
208cc |
3000-6000 ft |
74 |
| 6000-8000 ft |
73 |
| P5500 |
389cc |
3000-6000 ft |
103 |
| 6000-8000 ft |
101 |
| P6500 |
420cc |
3000-6000 ft |
107 |
| 6000-8000 ft |
105 |
Jet Installation
To change the carburetor main jet, follow this procedure:
| NOTICE |
| The air box may need to be removed in order to gain enough clearance to remove the main jet. |
- Turn off the fuel supply.
- Remove the maintenance cover.
- Access the carburetor drain screw. Drain the fuel from the carburetor into a suitable container.
- Remove the float bowl and chamber bolt.
- Remove the main jet from the carburetor.
- Install the correct main jet for the altitude in which the generator is operating. Do not over-tighten the jet.
- Re-install the float bowl and chamber bolt.
- Close carburetor drain screw.
- Re-install the maintenance cover.
- Turn on fuel supply. Start generator and let engine run for several minutes.
- Turn off generator. Verify there are no fuel leaks.
