Content Source: Polaris Power® P2000i Owner’s Manual (9931062 R01) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Engine Oil

Oil Recommendation

Oil Recommendation
POLARIS 5W-30 Generator Oil
Oil directly affects performance and service life. Use a 4-stroke automotive detergent oil, see Oil and Lubricants for recommended oil. Other viscosities may be used when the applicable average temperature is within the recommended range.
The SAE oil viscosity and service category are in the API label on the oil container. Polaris recommends the use of API service category “SJ” or later, equivalent oil.

Oil Level Inspection

IMPORTANT
  • Failure to use the proper 4-stroke engine oil may result in engine damage.
  • Using non-recommended oil may cause serious engine damage. Never substitute or mix oil brands.
  • Inspect the oil level before each use with the engine stopped and the generator on a level surface.
  1. Remove the oil filler cap / dipstick and wipe it clean.
  2. Insert the dipstick into filler neck, without screwing it in, to inspect the oil level.
  3. Remove the dipstick and verify that the oil is at the upper limit. Add additional oil and inspect the level as needed until the upper limit has been reached.
  4. Re-install the dipstick. Use a clean shop rag to clean any spilled oil.
NOTICE
  • Do not tilt generator when adding engine oil. This could result in overfilling and damage to the engine.
  • Use high quality 4-stroke engine oil, certified to meet or exceed API standard SG, SF, SAE ratings with strong detergents. Using non-detergent or 2-stroke oil could shorten the engine’s working life.
  • Do not mix different engine oils.
  • Handle and store the engine oil with care, avoid getting dirt or dust into the engine oil.
  • Before the engine oil falls below the safety margin, the low oil alert system ill automatically shut off the engine. The low oil light (RED) will illuminate.
  • To avoid the inconvenience of unexpected engine shutdown, check oil level before each use.

Oil Change

WARNING
Oil may be hot. Do not allow hot oil to come into contact with skin, as serious burns may result.
NOTICE
Drain the oil while the engine is warm to assure rapid and complete draining.
IMPORTANT
Improper disposal of engine oil can be harmful to the environment and is unlawful. Properly dispose of used oil.
  1. Start the engine and allow it to run for a few minutes. Stop the engine.
  2. Position the fuel valve switch and fuel vent to OFF.
  3. Elevate the generator several inches to allow access to the drain bolt under the bottom tray.
  4. Remove the oil filler cap / dipstick.
  5. Place a drain pan under the generator.

  1. Remove the rubber grommet from the bottom of the tray.
  2. Unscrew drain bolt and remove the washer .
  3. Drain the used oil into a sealed container and take it to a recycling center. Do not discard the oil in a trash can, dump it on the ground, or pour it down the drain.

Image
  1. Re-install the oil drain bolt and replace the rubber plug.
  2. Optional: Place provided funnel into fill valve.
  3. Fill oil to the high limit mark on the dipstick. Ensure that the oil level does not rise past the threading of the cap.
    MEASUREMENT

    Oil Capacity

    13.6 oz (0.4 L)
  4. Remove funnel and re-install the dipstick.
  5. Start the engine and let it run for 1 or 2 minutes. Stop the engine and look for leaks.
  6. Re-check the oil level on the dipstick and add oil as needed to bring the level to the upper mark on the dipstick.
  7. Re-install the dipstick.
  8. Wash hands with soap and water after handling used oil.

© Copyright Polaris Inc. All rights reserved.