Standby Power

Content Source: Polaris Power® P2000i Owner’s Manual (9931062 R01) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Standby Power

Connections to a Building Electrical System

WARNING

Improper connection to a building electrical system can allow current from the generator to back feed into the utility lines. Such back feed may electrocute utility company workers or others who contact the lines during a power outage.

Additionally, the generator may explode, burn, or cause fires when utility power is restored. Consult the utility company or a qualified electrician prior to making any power connections.

Connections for standby power to a building's electrical system must be made by a qualified electrician and must comply with all applicable laws and electrical codes. Improper connections can allow electrical current from the generator to back feed into the utility lines.

Such back feed may electrocute utility company workers or others who contact the lines during a power outage; when utility power is restored, the generator may explode, burn, or cause fires in the building's electrical system. Do not connect this generator to an automatic transfer switch. Serious damage to the engine and inverter module may result.

In some areas, generators are lawfully required to be registered with local utility companies. Check local regulations for proper registration and usage procedures.

Ground System

This generator is equipped with a system ground to prevent electrical shock from faulty appliances.

To ground this generator, perform the following steps:

Ensure engine is OFF and fuel valve switch is OFF.
Using a mallet, drive a grounding rod 4 ft. into the ground.
Wrap a length of bare copper grounding wire tightly around the grounding rod or use a grounding clamp.

Slightly loosen bolt on ground terminal. Allow enough space to wrap copper wire.
Using the other end of the copper wire, tightly wrap the wire around the terminal.

System Requirements

There may be federal or state Occupational Safety and Health Administration (OSHA) regulations, local codes, or ordinances that apply to the intended use of the generator. Please consult a qualified electrician, electrical inspector, or the local agency having jurisdiction.

If the generator is used at a construction site, there may be additional regulatory requirements.