Content Source: Polaris Power® P2000i Owner’s Manual (9931062 R01) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

AC Operation

WARNING
Before connecting a device or power cord to the generator, ensure it is in good condition. Faulty appliances or power cords can create a potential for electrical shock.
  • If an appliance begins to operate abnormally, becomes sluggish, or suddenly stops, immediately shut it off. Disconnect the appliance and determine whether the problem is the appliance or if the rated load capacity of the generator has been exceeded.
  • Ensure the combined electrical rating of the device or appliance does not exceed the maximum allowed by the generator. Never exceed the maximum power rating of the generator. Do not exceed the current limit specified for any one receptacle. Power levels between rated and maximum may be used for no more than 30 minutes.
IMPORTANT: Before connecting a device or power cord to the generator, ensure the device or cord is in good condition and electrical rating does not exceed the maximum amount allowed by the generator.
Image
  1. Start engine. See Starting the Engine for additional instruction.
  2. Confirm the desired appliance is switched off. Then plug the appliance or extension cord into one of the AC receptacles .
  3. Turn on the appliance.
NOTICE
Should the generator's maximum load of 25 amps be exceeded, the circuit protection device will trip and cut all current to the receptacles. The engine will continue to run.Correct the load by unplugging all appliances from the receptacles and press-in the circuit protector button to reset, followed by the Overload Reset button. AC power will be restored immediately.

AC Capacity

Model Max Power Rated Power
P2000i 1600 W 2000 W
NOTICE
In case of substantial overloading, the electronic circuit protector will activate. Slightly overloading the generator or running at maximum power operation (30 minutes) may not switch the circuit ON, but will shorten the service life of the generator.
Consider total power requirements of all connected devices. Appliance and power-tool manufacturers typically list rating information near the model or serial number.
After plugging in a device, allow the generator to stabilize before plugging in additional items. Always consider generator capacity before plugging in any device.
Typical wattages are listed in the table below. Before plugging any device into the generator, verify the manufacturer-listed wattage on the device.

Wattage Reference Table

Device Running (Rated) Watts Additional Starting (Surge) Watts
Table Saw / Radial Arm Saw - 10” 2000 2000
Space / Wall Heater 1800 0
Central Air Conditioning 1500 4500
Circular Saw - 7 1/4” 1400 2300
Hair Dryer 300 - 1200 0
Sump Pump - 1/2 HP 1050 2200
Microwave Oven - 100 Watt 1000 1400
Coffee Maker 1000 0
Garage Door Opener 1/2 HP 875 2350
Personal Computer w/ 17” Monitor 800 0
Refrigerator 400 - 800 2200
Dehumidifier 650 800
Color Television - 27” 500 0
Electric Drill - 3/8”, 4 amps 440 600
Paint Sprayer 360 1080
Radio 300 300
Oven 60 7500
Light Bulb - 75 Watt 75 0

Power Management Example

Device Running (Rated) Watts Additional Starting (Surge) Watts
Radio 300 300
Personal Computer w/ 17” Monitor 800 0
Light Bulb (75 W) 75 0
  • 1175 = Total Running (Rated) Watts
  • 300 = Additional Starting (Surge) Watts
  • 1475 = Total Generator Output Required
caution
Ensure the combined electrical rating of the powered device(s) do not exceed the maximum output allowed by the generator. Never exceed the maximum power rating of the generator. Power levels between rated and maximum may be used for no more than 30 minutes.

© Copyright Polaris Inc. All rights reserved.