Content Source: 2020 PRO XD Diesel Owner’s Manual (9930999 R01) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Fuel Filter / Water Separator

The fuel filter/water separator is located under the seat on the left side of the vehicle, between the engine and fuel tank.
Inspect the separator daily for leaks. Drain water and replace the separator at the intervals outlined in the Periodic Maintenance Chart. Service the separator more frequently if the vehicle is operated with inferior fuel.
caution
Both fuel and water will drain from the separator during the following procedure. Use caution and observe all fuel safety precautions when handling fuel.
  1. Be sure the engine is at room temperature.
  2. Disconnect the battery.
  3. Remove the seat.
  4. Remove the storage bin.
  5. Locate the fuel filter / water separator.
    Image
  6. Place an appropriate container under the fuel filter area to catch any excess fuel from the drain valve.
  7. Unscrew the drain value 1/2 to 1 full turn until fuel starts to drain from the bottom – do NOT unscrew the valve completely.
    IMPORTANT

    The drain valve has standard threads.
    Image
  8. Wait for fuel and water to stop draining and then firmly retighten valve.
  9. Clean up any excess fuel.
  10. Reconnect the battery.
  11. Prime the fuel system by turning the ignition switch to the “ON” position for 10–15 seconds.
  12. Start the engine and verify that no fuel leaks are present.
  13. Reinstall the seat.

© Copyright Polaris Inc. All rights reserved.