Starting the Engine

Content Source: 2020 Ranger Diesel (Poland) Owner’s Manual (9930939 R02) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Starting the Engine

NOTICE

NEVER use an engine starting aid such as ether. Engine damage will result.

The ignition system is marked by the OFF

, LIGHTS ON

, POSITION LIGHTS ON

, and START

symbols.

Before operating this vehicle in cold weather, review the cold weather operation information on Cold Weather Operation. Always wait for the glow plug indicator light to turn off before cranking the engine.

Always start the engine outdoors or in a well-ventilated area.
Sit in the driver's seat and fasten the seat belt. Secure the cab nets.
Place the transmission in PARK.
Apply the brakes. Do not press the throttle pedal while starting the engine.
Turn the ignition switch to the LIGHTS ON position and wait for the glow plug indicator light to turn off.
Turn the ignition key to the START position. Engage the starter for a maximum of five seconds. Release the key when the engine starts. Turn the key to either LIGHTS ON or POSITION LIGHTS ON.
If the engine does not start within five seconds, return the ignition switch to the OFF position and wait five seconds. Repeat steps 6 and 7 until the engine starts.

NOTICE

Operating the vehicle immediately after starting could cause engine damage. Allow the engine to warm up for several minutes before operating the vehicle. After letting the engine warm up in this way, operate the vehicle at medium speed without load for several minutes to further warm up the engine.