Switches

Content Source: 2020 Ranger Diesel (Poland) Owner’s Manual (9930939 R02) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Switches

Ignition Switch / Light Switch

Use the ignition switch to start the engine and to turn the lights on or off. The key can be removed from the switch when it is in the OFF position.

	OFF	Turn the key to the OFF position to stop the engine. Electrical circuits are off.
	LIGHTS ON	All lights are on. Electrical circuits are on. Electrical equipment can be used.
	POSITION LIGHTS ON	The headlights are off. Position lights are on. Electrical equipment can be used.
	START	Turn the key to the START position to engage the electric starter. See the Starting the Engine section for details.

Turn Signal Lever

Before turning, activate a turn signal to alert others of your intentions. Check turn signal lamps before each ride.

TIP

The key must be in the ON position to activate the turn signals.

Move the turn signal lever downward to signal a left turn. The left turn signal lamps in the taillight and below the front headlight will flash. The turn signal indicator in the gauge will also flash.
Move the lever upward to signal a right turn. The right signal lamps and indicator will flash.
Return the lever to the center position to end the signal.

AWD Switch

The AWD switch has three positions: All Wheel Drive (AWD), Differential Lock/Two Wheel Drive (2WD) and Off (1WD/Turf Mode).
Press the top of the switch to engage All Wheel Drive (AWD).
Move the switch to the center position to lock the differential and operate in two wheel drive (2WD).
Press the bottom of the switch to unlock the differential and allow the rear drive wheels to operate independently (1WD). This mode of operation is well suited to turf driving or when active traction is not needed.

Hazard Switch

Push the hazard warning switch to cause all turn signal lights to flash simultaneously. Both turn signal indicators on the console will also flash. Use this feature to alert others of an emergency or other situation requiring caution.

ADC Switch

The ADC switch has two positions, ON/OFF. ADC will activate when all of the following conditions are met:

AWD mode is engaged.
No throttle applied.
Vehicle speed is between 1-12.5 MPH.
ADC switch is in ON position.

Park Brake/Glow Plug Indicator

The park brake indicator illuminates when the park brake is engaged. The glow plug indicator illuminates when the glow plugs are active. The indicator turns off when the engine is ready to start.