Hitches

Content Source: 2020 Ranger Diesel (Poland) Owner’s Manual (9930939 R02) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Hitches

WARNING

Whenever the vehicle is towing, always stay clear of the area between the vehicle and the towed object.

Rear Hitch

Use the rear hitch (if equipped) for towing a trailer.

Rear Hitch Specifications
Material	S355J2+N
Fasteners	Metal pin with security cotter pin
Weld Length and Positions	7 mm fillet, all around
Maximum Vertical Load	173 kg applied on coupling point
Maximum Towable Mass	326 kg
Approval #	E9-55R-01.6126

Hitch Removal / Installation

To remove the hitch (if equipped), remove the cotter pin and hitch pin . Remove the hitch, then reinstall the hitch pin and secure the cotter pin .
To install the hitch, remove the cotter pin from the hitch pin and remove the hitch pin .
Install the hitch to the receiver.
Reinstall the hitch pin (from the left side of the hitch) through the bore of both the receiver and the hitch.
Reinstall the cotter pin. Make sure the hitch assembly is secure at that the cotter pin is properly engaged over the hitch pin.

7-Way Trailer Connector

The 7-way trailer connector

installed on your vehicle meets the requirements of European standard ISO 1724.

This connector uses all 7 pins on newer model trailers. An older model trailer may not be compatible with this connector.

Improper electrical wiring changes can result in damage to both vehicle and trailer components. When in doubt about your trailer connection, please contact a qualified towbar specialist for assistance.