Content Source: 2020 Slingshot Owner’s Manual (9930921 R01) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Operating Cruise Control

The cruise control switches/buttons are located on the steering wheel. Make sure you read this section and understand how to safely operate this feature before using the cruise control.
WARNING
Improper operation of cruise control could cause loss of control and result in serious injury or death. Follow all cruise operation procedures carefully. Never use cruise control when roads are wet or slippery. Do not use cruise control when driving in heavy or congested traffic.
NOTICE
Cruise control functions will not be available until the brake has been applied firmly at least once after a restart of the vehicle.

Cruise Control Tips

  • Cruise control can be set in gears 3-5 (excluding vehicles with AutoDrive Transmission).
  • Vehicle speed must be above 30 MPH (48 km/h).
  • Set speed will vary slightly in hilly terrain.
  • The cruise control will not resume a pre-set speed if the resulting acceleration or deceleration rate is too high or too low. For example, resuming a set speed from 30 MPH (48 km/h) while in 5th gear may cause cruise to disengage.
  • Cruise control may not engage if brake lights are not operating properly.
  • Cruise control will be disabled if there is an active stability or traction control event.
  • Cruise control will be disabled if there are multiple wheel speed sensor faults or a communication error with the electronic stability module.

Set Speed

  1. Enable Cruise Control by pressing the top-right button.
  2. Accelerate to desired speed, then press the bottom-left button to set Cruise Control.
Button Function
Top-Left Resume Cruise Control / Increase Speed
Bottom-Left Set Cruise Control / Reduce Speed
Top-Right Enable Cruise Control
Bottom-right N / A
Image

Cancel Cruise Control

To temporarily cancel the cruise control and allow use of the resume feature, depress the brake pedal.
To cancel the cruise control and erase the set speed from memory, press the top-right button.

Resume Speed

  1. Disengage the cruise control by depressing the brake pedal.
    NOTICE
    If you depress the throttle pedal to accelerate, the cruise control will resume the previously set speed when the pedal is released.
  2. Press the top-left button to resume operation at the previously set speed.
    NOTICE
    Pressing the top-right button will erase the set speed from memory and disengage the cruise control.

Adjust Speed Setting

Once Cruise Control is enabled and a cruising speed has been set, use the left-side buttons to increase and reduce cruising speed by 1 MPH (1.61 km/h) increments.
Press the top-left button to increase speed.
Press the bottom-left button to decrease speed.

© Copyright Polaris Inc. All rights reserved.