Content Source: 2020 Slingshot Owner’s Manual (9930921 R01) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Hydraulic Clutch Fluid
(Manual Transmission Only)

The clutch fluid reservoir is located under the hood on the driver’s side of the vehicle. Check the hydraulic clutch fluid level before each use of the vehicle. Maintain the fluid level between the MIN and MAX lines on the reservoir.
Use DOT 4 brake fluid in the hydraulic clutch fluid reservoir. Use fluid only from a sealed, clean container. Review the brake fluid precautions on Brake Fluid Precautions.
NOTICE
Brake fluid will damage painted surfaces and plastic parts. Always clean spilled brake fluid immediately with water and a mild detergent.
Image

Clutch Fluid Level

  1. Position the vehicle on a level surface.
  2. Place the transmission in gear.
  3. Open the hood.
  4. Wipe the fluid container and the area around the reservoir cover with a clean cloth.
    WARNING
    Using the wrong fluid or allowing air or contaminants into the fluid system can damage the system seals or result in a malfunction that could lead to serious injury or death. Do not operate the clutch while the reservoir cover is removed. Fluid could overflow from the reservoir and cause air to enter the fluid system.
  5. View the fluid level in the reservoir. If the fluid level is below the MIN line on the reservoir, remove the cap and add the recommended fluid to the MAX line. Do not overfill.
  6. Reinstall the reservoir cap.
  7. Depress the clutch pedal forcefully for a few seconds. Check for fluid leakage around the clutch reservoir fittings.

Clutch Fluid Change

Always change fluid if the fluid becomes contaminated, if the fluid condition is questionable, or if the type and brand of the fluid in the reservoir are unknown.
  1. Position the vehicle on a level surface.
  2. Place the transmission in gear.
  3. Open the hood.
  4. Wipe the fluid container and the area around the reservoir cover with a clean cloth.
    WARNING
    Using the wrong fluid or allowing air or contaminants into the fluid system can damage the system seals or result in a malfunction that could lead to serious injury or death. Do not operate the clutch while the reservoir cover is removed. Fluid could overflow from the reservoir and cause air to enter the fluid system.
  5. Using a syringe or vacuum-type tool, remove the old fluid from the fluid reservoir.
  6. Refill the reservoir to the MAX line with the recommended fluid. Do not overfill.
  7. Reinstall the reservoir cap.
  8. Depress the clutch pedal forcefully for a few seconds. Check for fluid leakage around the clutch reservoir fittings.

© Copyright Polaris Inc. All rights reserved.