AutoDrive System

Content Source: 2020 Slingshot Owner’s Manual (9930921 R01) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

AutoDrive System

WARNING

This vehicle is equipped with an AutoDrive system that is, in effect, similar to a conventional automatic transmission. However, there are some key differences in how the AutoDrive system handles by comparison. Read the information below to understand the performance of the AutoDrive system. Failure to follow recommended precautions and procedures in this section could result in serious injury or death.

When operating at low speeds without the accelerator depressed, the AutoDrive system will close the clutch, causing the vehicle to slow down independent of the brake pedal. This function does not replace the brake pedal. ALWAYS use the brake pedal to come to a complete stop. NEVER rely solely on engine braking to come to a complete stop.
Making the vehicle “creep” slower than approximately 6 MPH (10 km/h) will cause the clutch to heat up and may result in overheating and excessive clutch wear.
Making the vehicle maintain position on a hill using solely the engine may cause the clutch to heat up and may result in overheating and excessive clutch wear. Always use the brakes (parking brake or foot pedal) to maintain position on a hill.
At times, the AutoDrive system may feel different than a conventional automatic transmission. Engaging Comfort Mode or reducing throttle at the time of shift can improve smoothness.
Unlike a conventional automatic, you will hear and feel the engine speed change during downshifts. This is normal operation.
When cornering, the AutoDrive system may delay shifts in order to avoid upsetting the vehicle and causing loss of traction. This may result in higher than expected engine speeds, but that is normal operation. Once the vehicle has finished cornering, the AutoDrive system will continue to shift as normal.