Switches

Content Source: 2020 RANGER XP 1000 Tractor Owner’s Manual (9930870 R01) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Switches

Not all switches are present on every model.

Ignition Switch / Light Switch

Use the ignition switch to start the engine and to turn the lights on or off. The key can be removed from the switch when it is in the OFF position.

	OFF	Turn the key to the OFF position to stop the engine. Electrical circuits are off.
	LIGHTS ON	All lights are on. Electrical circuits are on. Electrical equipment can be used.
	POSITION LIGHTS ON	The headlights are off. Position lights are on. Electrical equipment can be used.
	START	Turn the key to the START position to engage the electric starter. See the Starting the Engine section for details.

Turn Signal Lever

Before turning, activate a turn signal to alert others of your intentions. Check turn signal lamps before each ride.

TIP

The key must be in the ON position to activate the turn signals.

Move the turn signal lever downward to signal a left turn. The left turn signal lamps in the taillight and below the front headlight will flash. The turn signal indicator in the gauge will also flash.
Move the lever upward to signal a right turn. The right signal lamps and indicator will flash.
Return the lever to the center position to end the signal.

Driveline Mode Switch

The Driveline Mode Switch has three positions: All Wheel Drive (AWD), Differential Lock/Two Wheel Drive (2WD) and Off (Turf Mode).

AWD: Press the top of the switch to engage All Wheel Drive (AWD).
2WD: Move the switch to the center position to lock the differential and operate in two wheel drive (2WD).
TURF Mode: Press the bottom of the switch for Turf Mode (unlocked differential power). In Turf Mode, the rear drive wheels operate independently (1WD) depending on tire traction. This mode of operation is well suited to turf driving or when active traction is not needed.

Hazard Switch

Push the hazard warning switch to cause all turn signal lights to flash simultaneously. Use this feature to alert others of an emergency or other situation requiring caution.