Switches

Content Source: 2020 RS1 Owner’s Manual (9930796 R02) > Features and Controls Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Switches

Ignition Switch

The ignition switch

is a four-position, key-operated switch. Use the ignition switch to start the engine. See Starting the Engine for engine starting procedures.

Position	Function
OFF	The engine is off. Electrical circuits are off, except accessory 12V.
ACCESSORY	The engine is off. Provides power to the accessory terminal block.
ON	Electrical circuits are on. Electrical equipment can be used.
START	Turn the key to the START position to engage the electric starter. The key returns to the ON position when released.

The key can be removed from the switch when it is in the OFF position.

Headlight Switch

The ignition switch key must be in the ON/RUN position to operate the headlights. Press the top of the switch to place the headlights on high beam. Move the switch to the center position to place the headlights on low beam. Press the bottom of the switch to turn off the headlights.
If the headlight switch is ON when the ignition switch is turned off, the lights will remain on for approximately 20 seconds.

All Wheel Drive (AWD) Switch

The AWD switch has two positions:

All Wheel Drive (AWD)
Two Wheel Drive (2WD)

Press the top of the rocker switch to engage All Wheel Drive. Press the bottom of the switch to operate in two wheel drive. See the All Wheel Drive (AWD) System section for AWD operating instructions.