Content Source: 2020 RS1 Owner’s Manual (9930796 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Suspension Settings

Front / Rear Spring Preload Adjustment

The factory setting is appropriate for nearly all riding conditions. If desired, the suspension may be adjusted to maintain vehicle clearance height when carrying loads.
Image
Image
Front Shock Rear Shock
To adjust the preload, do the following:
  1. Elevate the vehicle to allow the suspension to fully extend.
  2. Turn the adjusting ring to the left to increase preload for a higher ride height. Turn the adjusting ring to the right to decrease preload for a lower ride height.
Factory Preload Settings
RZR RS1 Front

3.0 inches (76 mm)
Rear

9.3 inches (236 mm)
Follow these guidelines if you make adjustments to this suspension.
  • Always return the suspension to the factory setting after the load is removed from the vehicle. The increased suspension height will negatively impact vehicle stability when operating without a load.
  • Always apply the same adjustment setting to all four wheels.
Do not increase the spring preload by more than one inch (25.4 mm) over the factory setting.

Front / Rear Shock Compression Adjustment

Image
Image
The compression damping clicker knob on the front shocks is located at the top of the shock reservoir . For the rear shocks, the clicker knob is located directly below the shock reservoir .
To adjust the compression dampening, do the following:
  1. Turn the clicker clockwise to increase compression damping.
  2. Turn the clicker counter-clockwise to decrease compression damping.
Shock Compression Settings
Model Location Factory Clicker Position
RZR RS1 Front 8/16 clicks
Rear 8/16 clicks

© Copyright Polaris Industries Inc. All rights reserved.