Content Source: 2020 RS1 Owner’s Manual (9930796 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Filter Systems

Air Filter

Always change the air filter at the intervals outlined in the Periodic Maintenance Chart.

Image

Image
  1. Remove the rear close-off panel located behind the seat.
  2. Clean all dirt and debris from the air box area.
  3. Unlatch the air box cover clips and carefully remove the air box cover.
  4. Inspect the air filter and air box for dirt, debris or water.
  5. To remove the filter, slide the filter to the left, as you are looking to the rear of the vehicle.
  6. With the filter removed, clean the intake tube and air box thoroughly. Wipe well with a clean, dry cloth.
    NOTICE
    Dirt or debris in the intake tube could result in severe engine damage. Always clean all dirt and debris from the intake tube before installing the filter.
  7. Reinstall the air filter (if clean) or install a new air filter (if soiled). Do not attempt to clean the air filter.
    NOTICE
    Use of a non-POLARIS-approved air filter may cause engine damage. Always use a POLARIS-approved replacement filter. Replacement filters are available at your POLARIS dealer.
  8. Make sure that there are no gaps between the filter, the filter ring and the stop on the intake tube.
  9. Reinstall the air box cover and ensure the hinge is properly aligned.
  10. Secure the cover clips.
  11. Reinstall the access panel.

© Copyright Polaris Industries Inc. All rights reserved.