Content Source: 2020 GEM e2/e4/e6/eXLD Owner’s Manual (9930628-EN R01) > Safety Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Operator Safety

WARNING
Serious injury or death can result if you do not follow these instructions and procedures, which are outlined in further detail within this owner's manual.
  • Read this manual and all labels carefully. Follow the operating procedures described.
  • Never allow anyone under age 16 to operate this vehicle and never allow anyone without a valid driver's license to operate this vehicle.
  • Never permit a guest to operate this vehicle unless the guest has read this manual and all product labels.
  • Always make sure the seat belts are secured for operator and all passengers before operating.
  • Never exceed the maximum occupant capacity of your vehicle:

    GEM e2

    2 occupants

    GEM e4

    4 occupants

    GEM e6®

    6 occupants

    GEM eL XD

    2 occupants

  • Never exceed the gross vehicle weight rating (GVWR) of your vehicle.
  • The cab frame is not designed or intended to provide rollover protection. Avoid situations that could result in a rollover.
  • Always be sure there are no obstacles or people behind your vehicle when operating in reverse. When it’s safe to proceed in reverse, move slowly. Avoid turning at sharp angles in reverse.
  • Always use the proper size and type of tires and always maintain proper tire pressure as specified in this manual and on safety labels.
  • Never modify this vehicle with non GEM-approved parts and/or accessories.
  • Always set the park brake and remove the key when leaving the vehicle unattended.
  • The voltage in the battery pack is sufficient to cause death by electrocution. With the exception of battery inspections, never attempt to perform service on the electric drive system, including the battery pack, unless you are properly trained to work on electrical systems. Your authorized GEM dealer can provide battery-related service.
  • Do not carry a passenger until you have at least two hours of driving experience with this vehicle.
  • Always keep arms and legs inside the cab frame while the vehicle is in motion.
  • Always keep both hands on the steering wheel and both feet on the floorboards of the vehicle during operation.
  • Never consume alcohol or drugs before or while operating this vehicle.
  • Never operate at excessive speeds. Always travel at a speed proper for the traffic, visibility and operating conditions, and your experience.
  • Never attempt wheelies, jumps, doughnuts or other driving stunts.
  • Always inspect your vehicle each time you use it to make sure it's in safe operating condition. Always follow the inspection and maintenance procedures and schedules described in this manual.
  • Never operate on excessively rough, slippery or loose terrain.
  • Always follow proper procedures for turning. Practice turning at slow speeds before attempting to turn at faster speeds. Never turn at excessive speeds.
  • Always have this vehicle inspected by an authorized GEM service dealer if it has been involved in an accident.

Gross Vehicle Weight Rating (GVWR)

WARNING
Exceeding the gross vehicle weight rating of your vehicle can reduce stability and handling and could cause loss of control. NEVER exceed the GVWR of your vehicle.
The maximum payload capacity of your vehicle is the maximum weight you may add to your vehicle without exceeding the GVWR. This capacity is determined by calculating the difference between your vehicle’s GVWR and wet weight.
Refer to the specification section of this manual or the Manufacturer’s Label on the vehicle for model-specific information.
When determining the weight, you will be adding to your vehicle, and to ensure you do not exceed the maximum payload capacity, include the following:
  • operator body weight
  • passenger body weight
  • weight of all occupants’ apparel and items in or on apparel
  • weight of any options or accessories and their contents
  • weight of any additional cargo on the vehicle

Equipment Modifications

Never install any accessory that grounds to the vehicle chassis. The chassis is a floating ground to protect against electrical short circuits and hazards.
Do not install any non-GEM-approved accessory or modify the vehicle including for the purpose of increasing speed or power.
The warranty on your GEM vehicle may be voided if any non-GEM-approved equipment and/or modifications have been added to the vehicle.
WARNING
Any modifications or installation of non-GEM-approved accessories could create a substantial safety hazard and increase the risk of bodily injury.
The addition of certain accessories, including (but not limited to) mowers, blades, tires, sprayers, or large racks, may change the handling characteristics of the vehicle. Use only GEM-approved accessories, and familiarize yourself with their function and effect on the vehicle.

Seat Belts

Riding in this vehicle without wearing the seat belt increases the risk of serious injury in the event of an accident or sudden stop. Occupants must wear seat belts at all times. Always make sure the seat belts are secured for operator and all passengers before operating.
WARNING
Always wear your seal belt. Ensure the seat belts are secured for operator and all passengers before operating. Failure to do so could result in the risk of serious injury or death.

Operating Without Instruction

Image

Operating this vehicle without proper instruction increases the risk of an accident. The operator must understand how to operate the vehicle properly in different situations and on different types of terrain. All operators must read and understand the Owner's Manual and all warning and instruction labels before operating the vehicle.

Ventilation When Charging Batteries

WARNING
Maintenance and storage areas for Low Speed Vehicles (LSVs) must be properly ventilated, in accordance with applicable fire codes and ordinances, to prevent the accumulation of volatile hydrogen gas. Hydrogen gas is emitted during the LSV battery charging process. If not properly ventilated, hydrogen gas has a tendency to accumulate in pockets near the ceiling which can lead to fires and explosions. The amount of hydrogen gas emitted during charging depends on a number of factors including the condition of the batteries, the output rate of the battery charger, and the amount of time the batteries are charged.
  • Always remove any storage covers from the vehicle and open any cab doors (if equipped) before charging.
  • Reset the charger by interrupting AC power for 15 seconds.
  • Always ensure a minimum of 1 to 5 air changes per hour in the charging area (depending on factors such as the number of vehicles charging).
NOTICE
The minimum number of air changes required per hour during LSV charging depends on a number of factors including the number of vehicles charging, the size of the storage space, and the amount of hydrogen gas emitted.
At least 1 air change per hour is recommended for 1 vehicle, but up to 5 air changes per hour can be required for multiple vehicles.
NOTICE
The process, SAE J1718, can be used to determine the amount of hydrogen gas an electric vehicle will generate while being charged in a residential garage.
Consult applicable fire and safety codes for more specific ventilation requirements and to ensure the proper use of explosion proof electrical equipment.

Failure to Inspect Before Operating

WARNING
Failure to inspect and verify that the vehicle is in safe operating condition before operating increases the risk of an accident. Always inspect the vehicle before each use to make sure it's in safe operating condition. Always follow all inspection and maintenance procedures and schedules described in the owner's manual. See the Periodic Maintenance Section of the Maintenance Chapter.

Using Alcohol or Drugs

WARNING
Operating the vehicle after consuming alcohol or drugs could adversely affect operator judgment, reaction time, balance and perception.
Never drink alcohol or use drugs or medications before or while operating this vehicle.

Operating a Damaged Vehicle

caution
Operating a damaged vehicle can result in an accident. After any rollover or accident, have an authorized GEM dealer or qualified service dealer inspect the entire machine for possible damage, including (but not limited to) brakes, accelerator, steering system and electrical system.

Operating at Excessive Speeds

caution
Operating this vehicle at excessive speeds increases the operator's risk of losing control. Always operate at a speed that's appropriate for your skills and the traffic, visibility and operating conditions.

Exhibition Driving

caution
Exhibition driving increases the risk of an accident or rollover. Never attempt wheelies, jumps, doughnuts or other stunts. Avoid exhibition driving.

Turning Improperly

caution
Turning improperly could cause loss of traction, loss of control, accident or rollover. Always follow proper procedures for turning. Never turn abruptly or at sharp angles. Never turn at high speeds. Practice turning at slow speeds before attempting to turn at faster speeds.

Vehicle Rollover

WARNING
Vehicle rollover could cause serious injury or death. The cab frame is not designed or intended to provide rollover protection. Always make sure the seat belts are secured for operator and all passengers before operating. Avoid situations that could result in a rollover. Avoid sharp turns and abrupt steering maneuvers

Carrying Cargo

Carrying loads on the roof could damage the roof and affect vehicle handling, which could result in an accident or rollover. Never carry loads on the roof of the vehicle.
Never exceed the stated load capacity for this vehicle. Cargo should be properly distributed and securely attached.
Reduce speed and follow the instructions on cargo warning labels for hauling cargo. Allow a greater distance for braking.

Improper Tire Maintenance

caution
Operating this vehicle with improper tires or with improper or uneven tire pressure could cause loss of control or accident. Always use the size and type of tires specified for your vehicle.
Always maintain proper tire pressure as described in the owner's manual and on safety labels.

Unauthorized Use of the Vehicle

Leaving the keys in the vehicle can lead to unauthorized use of the vehicle by someone without a driver’s license or without proper training. This could result in an accident or rollover. Always remove the key when the vehicle is not in use.

Hot Drive Systems

WARNING
The motor and controller are very hot during and after use of the vehicle. Hot components can cause burns and fire. Do not touch hot drive system components. Always keep combustible materials away from the drive system. Use caution when traveling near or through grass, brush or muddy conditions, especially dry grass or brush, and always inspect areas near the drive system afterwards. Promptly remove any grass or debris clinging to the vehicle.

Precautions During Maintenance

DANGER
The voltage in the battery pack is sufficient to cause death by electrocution. With the exception of battery inspections, never attempt to perform service on the electric drive system, including the battery pack, unless you are properly trained to work on electrical systems.
Your authorized GEM dealer can provide battery- related service.
WARNING
Do not work in or near the battery compartment or on any other electrical component of the vehicle while charging the batteries.
WARNING
Before servicing the vehicle’s electrical system, always disconnect the service disconnect first, then disconnect any electrical accessory connections, then disconnect the negative cable from the 12-volt battery, then disconnect the negative terminal from the main battery pack. For more information about disconnecting the service disconnect, see the Service Disconnect section for details.
Always follow all safety instructions in the maintenance portion of this owner’s manual, as well as the following:
  • Make sure the vehicle is properly immobilized before beginning any maintenance.
  • Always block the chassis securely before working under the vehicle.
  • Turn the key off and remove it from the vehicle.
  • Insulate any tools used within the battery area to prevent sparks or battery explosion caused by shorting the battery terminals or wiring. Remove the batteries, or cover the exposed terminals with an insulating material.

FOR MORE INFORMATION ABOUT SAFETY PLEASE CONTACT GEM CUSTOMER SERVICE.

GEM CUSTOMER SERVICE
Phone:855–RIDEGEM (855–743–3436)
Web:www. gemcar.com

© Copyright Polaris Inc. All rights reserved.