Content Source:
2020 Indian Chief, Chieftain, Springfield and Roadmaster Rider’s Manual
(9930566 R03) > Maintenance Chapter
| IMPORTANT |
|
The Owner's Manual for this vehicle contains
warnings, instructions and other information you must read and fully
understand
before safely riding or performing maintenance
on this vehicle.Always follow the warnings and instructions in Owner's
Manual.
Click the CONTENTS link above for the Table Of
Contents, or download a full PDF of the Owner Manual in the Owner
Support area
of Polaris.com
|
Changing Your Security System
PIN
To change your PIN,
you must have either the key fob or your existing valid PIN available
to gain access to the security system.
If the key fob is not detected or is not available
and you cannot remember your PIN, please see your INDIAN MOTORCYCLE
dealer.
Please read the entire
procedure before beginning.
- Turn the power switch
on. Do NOT start the engine. The security light and/or power switch
will turn on briefly until the key
fob is detected or until the valid, current
PIN is entered.
- Push or hold the
turn signal CANCEL switch for 10 seconds until the security light
and/or power switch turn on.
| NOTE |
| On models with Infotainment Display, a pop-up window will appear
during this procedure stating that the key fob is out of
range. |
- Enter either the
master PIN (see Identification
Number Records) or your current 4-digit rider PIN within 20 seconds.
If the PIN is successfully entered, the security light and/or power
switch will remain on and the horn will sound
briefly.
| TIP |
| If the valid PIN is not entered within 20 seconds, the security light
and/or power switch will flash for 10 seconds, then
the system will shut
down. Return to step 1 to try again. |
- Enter a new 4-digit
security PIN of your own choosing. If the PIN is successfully entered,
the security light and/or power
switch will remain on and the horn will sound
briefly. Proceed to step 5.
| TIP |
| If the 4-digit PIN is NOT successfully entered within 20 seconds,
the security light and/or power switch will flash for 10
seconds, then the
system exits the procedure. Return to step 1 to try again. |
- Re-enter the new 4-digit PIN. If this entry matches the
first entry, the security light and/or power switch will turn off
and the horn will sound briefly. The new rider
PIN has been saved. Record your
new rider PIN on Identification
Number Records.
| TIP |
| If the second entry is not entered within 20 seconds or does not
match the first entry, the security light and/or power switch
will flash for 10 seconds,
then the system exits the procedure. The new PIN was NOT saved. Continue
to use your former valid
PIN. Return to step 1 to try
again. |
