/www.w3.org/TR/xhtml1/DTD/xhtml1-transitional.dtd">
Content Source: 2020 RZR PRO XP and PRO XP 4 Owner’s Manual (9929980 R01) > Troubleshooting Chapter
IMPORTANT |
The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual. Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com |
Possible Cause | Solution |
---|---|
Loose, missing or kinked boost reference lines |
Replace boost reference lines |
Loose or missing intake system sensor connections |
Inspect connections, tighten or replace as needed |
Fouled or defective spark plugs |
Inspect, clean and/or replace spark plugs |
Worn or defective spark plug wires |
Your POLARIS dealer can assist. |
Incorrect spark plug gap or heat range |
Set gap to specs or replace plugs |
Loose ignition connections |
Check all connections and tighten |
Water present in fuel |
Replace with new fuel |
Low battery voltage |
Recharge battery to 12.8 VDC |
Kinked or plugged fuel tank vent line or filter |
Inspect and replace |
Incorrect fuel |
Replace with recommended fuel |
Clogged air filter |
Inspect and replace |
Clogged intake pre-filter |
Inspect and clean (with soapy water) or replace |
Other mechanical failure |
Your POLARIS dealer can assist. |
Possible Lean Fuel Cause | Solution |
Low or contaminated fuel |
Add or change fuel, clean the fuel system |
Low octane fuel |
Replace with recommended fuel |
Clogged fuel filter |
Your POLARIS dealer can assist. |
Low fuel pressure |
Your POLARIS dealer can assist. |
Loose, missing, torn or kinked boost reference line from manifold to fuel pressure regulator or blow-off valve |
Replace boost reference line |
© Copyright Polaris Industries Inc. All rights reserved.