Content Source: 2020 RZR XP Turbo S Velocity / XP Turbo S4 Velocity Owner’s Manual (9929978 R02) > Troubleshooting Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Drive Belt Wear / Burn

Possible Cause Solution

Driving onto a pickup or tall trailer in high range

Use low range during loading.

Starting out going up a steep incline

Use low range. See warnings on Driving Uphill.

Driving at low RPM or ground speed (3-7 MPH/ 5-11 km/h)

Drive at a higher speed or use low range more frequently. See the Gear Selector section for details.

Insufficient warm-up at low ambient temperatures

Warm the engine at least 5 minutes. With the transmission in neutral, advance the throttle to about 1/8 throttle in short bursts, 5 to 7 times. The belt will become more flexible and prevent belt burning.

Slow/easy clutch engagement

Use the throttle quickly and effectively.

Hauling heavy cargo/pushing at low RPM/low ground speed

Use low range only.

Utility use/plowing

Use low range only.

Stuck in mud or snow

Shift the transmission to low range and carefully use fast, aggressive throttle application to engage clutch.

WARNING! Excessive throttle may cause loss of control and vehicle rollover.

Climbing over large objects from a stopped position

Shift the transmission to low range and carefully use fast, brief, aggressive throttle application to engage clutch.

WARNING! Excessive throttle may cause loss of control and vehicle rollover.

Belt slippage from water or snow ingestion into the PVT system

Dry out the PVT (see PVT Drying). Prevent water from entering the PVT outlet duct (see POLARIS Variable Transmission (PVT) System). Inspect clutch seals for damage if repeated leaking occurs.

Clutch malfunction

Your POLARIS dealer can assist.

Poor engine performance

Check for fouled plugs or foreign material in gas tank or fuel lines. Your POLARIS dealer can assist.

Slippage from failure to warm up belt

Always warm up the belt by operating below 30 MPH (48 km/h) for one mile (1.5 km) and for 5 miles (8 km) or more when temperature is below freezing.

Wrong or missing belt

Install the recommended belt.

Improper break-in

Always break in a new belt and/or clutch. See Vehicle Break-in Period.

Failed belt

Remove the belt and clean away any debris from the clutch box, clutch duct and engine compartment. Install a new belt.

WARNING! Failure to remove ALL debris when replacing the belt could result in vehicle damage and severe injury or death. See the Belt Replacement / Debris Removal section for details.


© Copyright Polaris Industries Inc. All rights reserved.