Content Source: MY20 RZR XP/XP4 1000 High Lifter Owner’s Manual (9929977 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Suspension Settings

Front / Rear Spring Preload Adjustment

The factory setting is appropriate for nearly all riding conditions. If desired, the suspension may be adjusted to maintain vehicle clearance height when carrying loads.

Image

Image
To adjust the preload, do the following:
  1. Elevate the vehicle to allow the suspension to fully extend.
  2. Turn the adjusting ring to the left to increase preload for a higher ride height. Turn the adjusting ring to the right to decrease preload for a lower ride height.
Factory Preload Settings
RZR XP High Lifter Front

1.46 inches (3.71 cm)
Rear

6.32 inches (16.05 cm)
 
RZR XP 4 High Lifter Front

2.19 inches (5.57 cm)
Rear

8.05 inches (20.45 cm)
Follow these guidelines if you make adjustments to this suspension.
  • Always return the suspension to the factory setting after the load is removed from the vehicle. The increased suspension height will negatively impact vehicle stability when operating without a load.
  • Always apply the same adjustment setting to all four wheels.
Do not increase the spring preload by more than one inch (25.4 mm) over the factory setting.

Front / Rear Shock Compression Adjustment

The compression damping clicker knob is located at the top of the shock reservoir.
  1. Turn the clicker clockwise to increase compression damping.
  2. Turn the clicker counter-clockwise to decrease compression damping.
Image
Shock Compression Settings
Model Location Clicker Position
RZR XP High Lifter Front 8/16 clicks
Rear 8/16 clicks
RZR XP High Lifter Front 8/16 clicks
Rear 8/16 clicks

© Copyright Polaris Industries Inc. All rights reserved.