Vehicle Break-in Period

Content Source: 2020 RZR 570 Owner’s Manual (9929974 R03) > Operation Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Vehicle Break-in Period

The break-in period for your new POLARIS vehicle is the first 25 hours of operation, or the time it takes to use the first two tanks full of gasoline. No single action on your part is as important as a proper break-in period. Careful treatment of a new engine and drive components will result in more efficient performance and longer life for these components. Perform the following procedures carefully.

NOTICE

Excessive heat build-up during the first three hours of operation will damage close-fitted engine parts and drive components. Do not operate at full throttle or high speeds during the first three hours of use.

Use of any improper oils may cause serious engine damage. POLARIS Premium 4 Synthetic Oil is specifically formulated for your 4-cycle engine

Engine and Drivetrain Break-in

Fill the fuel tank with the recommended fuel. See Fuel Cap for details. Always exercise extreme caution whenever handling gasoline.
Check the oil level. See Oil Check for details. Add the recommended oil as needed to maintain the oil level in the safe operating range.
Complete the steps in the New Operator Driving Procedures outlined on New Operator Driving Procedures.
Avoid aggressive use of the brakes. See Brake System Break-in for details.
Vary throttle positions. Do not operate at sustained idle.
Pull only light loads.
Perform regular checks on fluid levels, controls and areas outlined in the Pre-Ride Inspection section. See the Pre-Ride Inspection section for details.
During the break-in period, change both the oil and the filter at 25 hours or one month.
Check fluid levels of transmission and all gearcases after the first 25 hours of operation and every 100 hours thereafter.

Brake System Break-in

Apply only moderate braking force for the first 50 stops. Aggressive or overly forceful braking when the brake system is new could damage brake pads and rotors.

PVT Break-in (Clutches/Belt)

A proper break-in of the clutches and drive belt will ensure a longer life and better performance. If a belt fails, always clean any debris from the duct and from the engine compartment.

Standard Break-in

Drive at slower speeds for the first 50 miles (80 km) of operation. Carry only light loads. Avoid aggressive acceleration, high-speed operation and prolonged operation at a specific RPM during this period.

Sand / Dune Break-in

Drive in low gear for the first 5 miles (8 km) of operation. Avoid prolonged low speed operation at high throttle. Avoid aggressive acceleration, high-speed operation and prolonged operation at a specific RPM during this period.