Tools

Content Source: 2020 RUSH / SWITCHBACK / Pro-S / XCR Owner’s Manual (9929780 R02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Tools

The belt removal L-wrench tool, spare belt, spark plug, and spark plug tool container are located behind the left engine compartment panel.

NOTE

Spare belt and spark plugs are not provided with the snowmobile.

L-Wrench

When properly engaged in the bracket, the L-wrench secures the fender to the console. To retrieve the L-wrench, rotate it counter-clockwise and slide it upward from the bracket. Return the L-wrench to the bracket and rotate it clockwise when it’s not in use.

Spark Plug Wrench

The spark plug wrench secures the spare belt/spark plug tool container to the front bumper. Remove the container to add or access a spare spark plug or belt.

Replacement Drive Belt

To insert a replacement drive belt into the spare drive belt container, do the following:

Rotate the spark plug wrench counter-clockwise to release it from the bracket.
Pull the wrench upward to remove it.
Tilt the container until the bracket detaches from the bumper tube.
Pull the container out of the compartment.
When placing a drive belt into the container, fold the belt as shown. Verify that the belt loop at the rear of the container is positioned slightly higher than the front loop.
Slide the container into the engine compartment at an angle.
Position the container bracket onto the bumper tube and rotate it downward.
Reinstall the spark plug wrench into the bracket and through the hole in the bumper tube.
Rotate the spark plug wrench clockwise until it locks into place.