Lighting and Warmers Power Management

Content Source: 2020 RUSH / SWITCHBACK / Pro-S / XCR Owner’s Manual (9929780 R02) > Features Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Lighting and Warmers Power Management

The following components are always powered when the engine is running:

Low Beam Headlights
Taillights/Brake Lights
Passenger Hand Warmers (if equipped)

The brake light is protected by a 2 amp mini fuse located in the protective bag above the clutch cover. If the brake light does not illuminate when the brake lever is pulled, check the fuse. If the fuse is blown, inspect the brake lever switch wire to verify it is not damaged. Replace the fuse. See Fuse Replacement.

NOTICE

Never replace a fuse with a fuse of a higher amperage rating.

The following components are powered only when the load shed relay is turned on:

High Beam Headlights
Driver Thumb/Hand Warmers

The engine management system turns on the load shed relay when both of the following conditions are met:

Engine speed exceeds 1400 RPM and
Chassis DC voltage exceeds 11 volts

NOTE

If engine speed drops below 1400 RPM or chassis DC voltage falls below 11 volts, the engine management system will turn off the load shed relay. The relay will not be turned on again until engine speed is greater than 2000 RPM.