Content Source: 2020 800 Titan Adventure Owner’s Manual (9929779 Rev 02) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Drive System

Transmission Fluid Level Check

The fill plug is located on the right side of the transmission. Access the fill plug using the following procedure. Maintain fluid level even with the bottom of the fill plug hole.
  1. Position vehicle on a level surface.
  2. Remove the right side panel.
  3. Remove the push rivets securing the lower right portion of the console.
    Image
  4. Remove the push rivet securing the right fender to the footrest.
    Image
  5. Carefully flex the right fender outward and down to gain access to the fill plug.
    Image
  6. Remove the fill plug and check the fluid level.
    Image
  7. If fluid level is not even with the bottom threads, add the recommended fluid as needed. Do not overfill.
  8. Reinstall the fill plug and torque to specification.
    TORQUE

    Transmission Fill / Drain Plug:

    12 ft - lbs (16 Nm)

Transmission Fluid Change

The drain plug is located on the bottom of the right side of the transmission. Access the drain plug using the following procedure.
  1. Position vehicle on a level surface.
  2. Remove the right side panel.
  3. Remove the push rivets securing the lower right portion of the console.
    Image
  4. Remove the push rivet securing the right fender to the footrest.
    Image
  5. Remove the fasteners securing the rear of the right fender to the footrest support.
    Image
  6. Carefully flex the right fender downward to gain access to the drain plug.
    Image
  7. Remove the fill plug .
    Image
  8. Place a drain pan under the transmission drain plug.
  9. Remove the drain plug and allow fluid to drain completely.
    NOTE

    Fluid may run down the fender before draining into the drain pan. Once fluid has drained completely, wipe up any residual fluid on the fender.

  10. Clean the drain plug magnetic surface.
  11. Reinstall the drain plug and torque to specification.
    TORQUE

    Transmission Fill / Drain Plug:

    12 ft - lbs (16 Nm)
  12. Add the recommended amount of fluid through the fill hole. Maintain the fluid level even with the bottom threads of the fill plug hole.
    FLUID CAPACITY

    Transmission Lubricant:

    AGL Synthetic Gearcase

    Transmission Capacity:

    29 oz. / 850 ml.
  13. Reinstall the fill plug and torque to specification.
    TORQUE

    Transmission Fill / Drain Plug:

    12 ft - lbs (16 Nm)
  14. Check for leaks. Dispose of used fluid properly.

© Copyright Polaris Industries Inc. All rights reserved.