Any qualified repair
shop or qualified person may maintain, replace, or repair the emission
control devices or systems on
your snowmobile. An authorized POLARIS dealer can perform
any service that may be necessary for your vehicle. POLARIS also
recommends POLARIS parts for emissions related service,
however equivalent parts may be used for such service. It is a potential
violation of the Clean Air Act if a part supplied by
an aftermarket parts manufacturer reduces the effectiveness of the
vehicle's
emission controls. Tampering with emission controls
is prohibited by federal law.
Emission Control Label
Your snowmobile
is equipped at the time of sale with an emission control information
(ECI) label and a factory-installed emissions
information hangtag. These items are required by
U.S. Environmental Protection Agency regulations. The ECI label is
permanently
affixed to either the right side of the tunnel or
the engine recoil cover. The ECI label should not be removed, even
after
you purchase the snowmobile. You may remove the
factory-installed emissions information hangtag, which is intended
solely
for your use in making a purchasing decision.
Emission Control Maintenance
Requirements
Your snowmobile
is certified to operate on gasoline with a minimum octane level of
87 (R+M)/2. If your snowmobile is equipped
with a check engine light and it comes on, you must
take your snowmobile to a qualified dealer for diagnostic service.
Specifications
and adjustments for engine tune-ups are located
in the Service Manual, which is available to your qualified service
technician.
Reverse (if equipped) must not be engaged during
engine tune-ups.
Owner's Responsibilities
Please read the
Snowmobile Engine Emissions Limited Warranty, and read the maintenance
section of your owner's manual. You
are responsible for ensuring that the specified
maintenance is performed. POLARIS recommends that you contact an authorized
POLARIS dealer, or other qualified person, to perform
any service that may be necessary.
Non-ionizing Radiation
This vehicle emits
some electromagnetic energy. People with active or non-active implantable
medical devices (such as heart
monitoring or controlling devices) should review
the limitations of their device and the applicable electromagnetic
standards
and directives that apply to this vehicle.
