Content Source: 2020 600R Owner’s Manual (9929778 R01) > Troubleshooting Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Suspension Troubleshooting

Problem Solution
Rear suspension bottoms-out too easily
  • Adjust torsion spring preload
  • Increase rear shock compression damping by turning screw clockwise
  • Increase torsion spring wire diameter (see your dealer)
Rides too stiff in the rear
  • Check for binding suspension shafts and grease all pivot points
  • Adjust torsion spring preload
  • Decrease rear shock compression valving by turning screw counter-clockwise (if Indy Select shock)
  • Change to lighter valving (if FOX shock)
  • Change track tension
Too much weight transfer when climbing
  • Adjust torsion spring preload
  • Adjust limiter straps
Too little weight transfer when climbing
  • Adjust torsion spring preload
  • Adjust limiter straps
Machine darts from side to side
  • See your dealer for ski alignment inspection
  • Make sure spindles and all steering components turn freely
  • Check for excessive play in steering assembly (see your dealer)
  • Ensure skags are straight on skis (see your dealer)
  • Adjust torsion spring preload
  • Check rail slide/replace if worn
  • Reduce ski pressure: Reduce IFS spring preload or reduce rear torsion spring preload
Front end pushes
  • Check for worn skags
  • Adjust torsion spring preload
  • Check for binding front suspension shafts and steering components, grease all pivot points (elevate front of machine)
  • Increase IFS preload (if equiped)
  • Install single skag (see your dealer)
  • Rotate RRSS to high position
Steering is heavy
  • Make sure spindles and all steering components turn freely
  • See your dealer for ski alignment inspection
  • Check skags and skis for damage
  • Reduce ski pressure: Increase front track spring preload, reduce IFS spring preload by adjusting cam, reduce rear torsion spring preload
Setting up for deep snow operation
  • Change worn rail slide

© Copyright Polaris Industries Inc. All rights reserved.