Content Source: 2020 Indy 120 Owner’s Manual (9929777 R01) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Spark Plugs

A new engine can cause temporary spark plug fouling due to the preservative added during the assembly process. Avoid prolonged idle speeds, which cause plug fouling and carbonization.
Refer to the specifications section for recommended spark plug type and gap.
NOTICE
Using non-recommended spark plugs can result in serious engine damage. Always use the spark plugs recommended for your snowmobile.
Spark plug condition is indicative of engine operation. The spark plug firing end condition should be read after the engine has been warmed up and the vehicle has been driven. Immediately check the spark plug for correct color.
WARNING
A hot exhaust system and engine can cause serious burns. Wear protective gloves when removing a spark plug for inspection.

Spark Plug Removal and Replacement

  1. Stop the engine.
  2. Remove the spark plug cap.
  3. Using the special wrench provided in the tool pouch, rotate the spark plug counterclockwise to remove it.
  4. Reverse the procedure for spark plug installation.
    TORQUE
    12-14 ft. lbs. (16-19 Nm)

Normal Plug

The normal insulator tip is gray, tan or light brown. There will be few combustion deposits. The electrodes are not burned or eroded. This indicates the proper type and heat range for the engine and the service.
TIP
The tip should not be white. A white insulator tip indicates overheating, caused by use of an improper spark plug or incorrect carburetion adjustments.

Wet Fouled Plug

The wet fouled insulator tip is black. A damp oil film covers the firing end. There may be a carbon layer over the entire nose. Generally, the electrodes are not worn. General causes of fouling are excessive oil, use of non-recommended oil, improper use of the choke, or incorrect carburetion adjustments.

© Copyright Polaris Industries Inc. All rights reserved.