Content Source: 2019 Indian Scout/Scout Sixty Owner’s Manual (9929711 R03) > Maintenance Chapter

IMPORTANT

The Owner's Manual for this vehicle contains warnings, instructions and other information you must read and fully understand before safely riding or performing maintenance on this vehicle.Always follow the warnings and instructions in Owner's Manual.

Click the CONTENTS link above for the Table Of Contents, or download a full PDF of the Owner Manual in the Owner Support area of Polaris.com

Headlight

Headlight Aim Inspection

On high beam, the center of highest intensity (appearing as a diamond shape) should be 7.5 in. (19 cm) lower than the headlamp bulb and centered straight ahead at 25 feet (7.6 m).
Image

Headlight Aim Adjustment

  1. To adjust the headlamp vertically, loosen the housing mount fastener and pivot the housing upward or downward. Tighten the fastener.
    TORQUE: 35 ft-lbs (47.5 Nm)
  2. To adjust the headlamp horizontally, loosen the headlight mounting bolt and pivot the headlight to the left or right. Tighten the bolt.
    TORQUE: 18 ft-lbs (24.4 Nm)
Image

Headlight Lamp Replacement

  1. Remove the headlight retaining screw .
  2. Lift the headlight upward and remove it from the base .
  3. Disconnect the wire harness .
  4. Remove the rubber boot from the rear of the headlight.
  5. Squeeze the bulb retainer and move it away from the bulb. Remove the bulb.
    TIP
    Avoid touching a halogen lamp with bare fingers. Oil from your skin leaves a residue, causing a hot spot that will shorten the life of the lamp. If a lamp is touched, clean it thoroughly with denatured alcohol.
  6. Install the new bulb and secure the retainer.Image
  7. Reinstall the rubber boot, making sure it seals around the bulb and headlight.
  8. Connect the wire harness.
  9. Reinstall the headlight to the base and tighten the screw.
    TORQUE: 36 in-lbs (4.1 Nm)

© Copyright Polaris Industries Inc. All rights reserved.